/*
ChibiOS - Copyright (C) 2006..2016 Giovanni Di Sirio
Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.
*/
#include "hal.h"
#include "ch.h"
/*
* Thread 1.
*/
THD_WORKING_AREA(waThread1, 128);
THD_FUNCTION(Thread1, arg) {
(void)arg;
while (true) {
palSetPad(GPIOC, GPIOC_LED1);
chThdSleepMilliseconds(250);
palClearPad(GPIOC, GPIOC_LED1);
chThdSleepMilliseconds(250);
}
}
/*
* Thread 2.
*/
THD_WORKING_AREA(waThread2, 128);
THD_FUNCTION(Thread2, arg) {
(void)arg;
while (true) {
palSetPad(GPIOC, GPIOC_LED2);
chThdSleepMilliseconds(500);
palClearPad(GPIOC, GPIOC_LED2);
chThdSleepMilliseconds(500);
}
}
/*
* Thread 3.
*/
THD_WORKING_AREA(waThread3, 128);
THD_FUNCTION(Thread3, arg) {
(void)arg;
/*
* Activates the serial driver 1 using the driver default configuration.
* PA9 and PA10 are routed to USART1.
*/
sdStart(&SD2, NULL);
palSetPadMode(GPIOA, 9, PAL_MODE_ALTERNATE(7)); /* USART1 TX. */
palSetPadMode(GPIOA, 10, PAL_MODE_ALTERNATE(7)); /* USART1 RX. */
while (true) {
chnWrite(&SD2, (const uint8_t *)"Hello World!\r\n", 14);
chThdSleepMilliseconds(2000);
}
}
/*
* Threads static table, one entry per thread. The number of entries must
* match NIL_CFG_NUM_THREADS.
*/
THD_TABLE_BEGIN
THD_TABLE_ENTRY(waThread1, "blinker1", Thread1, NULL)
THD_TABLE_ENTRY(waThread2, "blinker2", Thread2, NULL)
THD_TABLE_ENTRY(waThread3, "hello", Thread3, NULL)
THD_TABLE_END
/*
* Application entry point.
*/
int main(void) {
/*
* System initializations.
* - HAL initialization, this also initializes the configured device drivers
* and performs the board-specific initializations.
* - Kernel initialization, the main() function becomes a thread and the
* RTOS is active.
*/
halInit();
chSysInit();
/* This is now the idle thread loop, you may perform here a low priority
task but you must never try to sleep or wait in this loop. Note that
this tasks runs at the lowest priority level so any instruction added
here will be executed after all other tasks have been started.*/
while (true) {
}
}