diff options
Diffstat (limited to 'keyboards/handwired/splittest/readme.md')
| -rw-r--r-- | keyboards/handwired/splittest/readme.md | 14 |
1 files changed, 4 insertions, 10 deletions
diff --git a/keyboards/handwired/splittest/readme.md b/keyboards/handwired/splittest/readme.md index 3dbff32ed..33dbc6e80 100644 --- a/keyboards/handwired/splittest/readme.md +++ b/keyboards/handwired/splittest/readme.md @@ -4,7 +4,10 @@ Split Tester A two-switch tester built using two Pro Micros, mainly intended to test RGB on split keyboards. Seen here: https://www.instagram.com/p/BvCPNzynwrV/ Keyboard Maintainer: [Bakingpy/nooges](https://github.com/nooges) -Hardware Supported: Pro Micro +Hardware Supported: Pro Micro, Teensy 2.0 +Hardware Availability: + +**See each individual board for pin infomation** Make example for this keyboard (after setting up your build environment): @@ -15,12 +18,3 @@ Example of flashing this keyboard: make handwired/splittest:default:avrdude See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). - -Wiring ------- -- Add switches to both Pro Micros across B3 and B6 pins -- Add pull-up resistor to left side between VCC and F6 -- Add pull-down resistors to right side between GND and F6 -- Connect the following pins on both sides together: D0, D1, GND, VCC -- Add I2C 4.7kOhm resistors between D0 and VCC, and D1 and VCC -- Wire Di of RGB strip for each half to D2 |