| Commit message (Collapse) | Author | Age | Files | Lines | |
|---|---|---|---|---|---|
| * | Replace DEBOUNCING_DELAY (deprecated) with DEBOUNCE (#5997) | Drashna Jaelre | 2019-06-06 | 1 | -1/+1 |
| | | |||||
| * | Update to arm_atsam wait and timer routines | patrickmt | 2019-01-07 | 1 | -9/+3 |
| | | | | | | | | | | | | | Microsecond (us) delays are now handled by a busy wait loop according to MCU frequency. This replaces the system counter method which had an overhead of around 12us. TC5 device and supporting routines removed as it was the old us delay counter. wait_ms is now properly a macro to CLK_delay_ms. wait_us is now properly a macro to CLK_delay_us. Removed CLK_get_us as it has no use. All calls to CLK_get_ms() have been replaced by timer_read64() with corrected typing. All calls to CLK_delay_ms() have been replaced by wait_ms(). All calls to CLK_delay_us() have been replaced by wait_us() and timings verified or updated as needed after review on scope. Corrected typing of variables using 64bit ms timer readings if needed. | ||||
| * | Bringing Massdrop keyboard hardware configuration to keyboard level (#4593) | patrickmt | 2018-12-10 | 1 | -3/+3 |
| | | | | | | | | | | | MCU Pins for debugging, LED, boot tracing, and shift registers are now configurable at keyboard level. Macros led_* replaced by DBG_LED_* Macros m15_* replaced by DBG_1_* Macros m27_* replaced by DBG_2_* Macros m28_* replaced by DBG_3_* For CTRL and ALT keyboards, debug boot tracing pin default now set to pad M27 instead of M28 since although M28 is not being used, it is technically a signal for USB port detection. m15_print(...) renamed to dbg_print(...) to get away from hard coded port names. dbg_print function now follows similar pattern to debug led output. | ||||
| * | move massdrop boards into its own directory for configurator visibility | mechmerlin | 2018-08-29 | 1 | -0/+182 |
 |
index : avr/qmk/firmware | |
| [no description] |
| aboutsummaryrefslogtreecommitdiffstats |