diff options
Diffstat (limited to 'LUFA/DoxygenPages/ProgrammingApps.txt')
-rw-r--r-- | LUFA/DoxygenPages/ProgrammingApps.txt | 9 |
1 files changed, 6 insertions, 3 deletions
diff --git a/LUFA/DoxygenPages/ProgrammingApps.txt b/LUFA/DoxygenPages/ProgrammingApps.txt index c1b2181c8..4759ac87a 100644 --- a/LUFA/DoxygenPages/ProgrammingApps.txt +++ b/LUFA/DoxygenPages/ProgrammingApps.txt @@ -9,8 +9,8 @@ * Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your * application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the * reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the - * supported AVR programming protocols - ISP, HVSP, HVPP, JTAG or dW. This can be done through a custom programmer, - * a third party programmer, or an official Atmel AVR tool - for more information, see the Atmel.com website. + * supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer, + * a third party programmer, or an official Atmel AVR tool - for more information, see the <a>atmel.com</a> website. * * Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel * DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the @@ -19,9 +19,12 @@ * or broken without an external programming device. They have disadvantages however; they cannot change the fuses of * the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the * AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the - * loaded application. Atmel's DFU bootloader is either 4KB (for the smaller USB AVRs) or 8KB (for the larger USB AVRs). + * loaded application. * * If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation. * Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible) * alternative exists called "dfu-programmer". + * + * \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader + * programming makefile targets. */ |