3 files changed, 4 insertions, 4 deletions
diff --git a/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c b/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
index ccd31f3d2..42e436cdf 100644
--- a/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
+++ b/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
@@ -230,7 +230,7 @@ void ISPProtocol_ProgramMemory(uint8_t V2Command)
 			if (ProgrammingStatus != STATUS_CMD_OK)
 			  break;
 
-			/* Must reset the polling address afterwards, so it is not erronously used for the next byte */
+			/* Must reset the polling address afterwards, so it is not erroneously used for the next byte */
 			PollAddress = 0;
 		}
 		
diff --git a/Projects/AVRISP-MKII/Lib/ISP/ISPTarget.c b/Projects/AVRISP-MKII/Lib/ISP/ISPTarget.c
index 373e19149..f08ee6a0e 100644
--- a/Projects/AVRISP-MKII/Lib/ISP/ISPTarget.c
+++ b/Projects/AVRISP-MKII/Lib/ISP/ISPTarget.c
@@ -140,7 +140,7 @@ ISR(TIMER1_COMPA_vect, ISR_BLOCK)
 	PINB |= (1 << 1);
 }
 
-/** Initialises the appropriate SPI driver (hardware or software, depending on the selected ISP speed) ready for
+/** Initializes the appropriate SPI driver (hardware or software, depending on the selected ISP speed) ready for
  *  communication with the attached target.
  */
 void ISPTarget_EnableTargetISP(void)
@@ -186,7 +186,7 @@ void ISPTarget_DisableTargetISP(void)
 }
 
 /** Configures the AVR to produce a .5MHz rescue clock out of the OCR1A pin of the AVR, so
- *  that it can be fed into the XTAL1 pin of an AVR whose fuses have been misconfigured for
+ *  that it can be fed into the XTAL1 pin of an AVR whose fuses have been mis-configured for
  *  an external clock rather than a crystal. When used, the ISP speed must be 125KHz for this
  *  functionality to work correctly.
  */
diff --git a/Projects/AVRISP-MKII/Lib/V2Protocol.c b/Projects/AVRISP-MKII/Lib/V2Protocol.c
index f763d6333..4c8f0585a 100644
--- a/Projects/AVRISP-MKII/Lib/V2Protocol.c
+++ b/Projects/AVRISP-MKII/Lib/V2Protocol.c
@@ -50,7 +50,7 @@ ISR(WDT_vect, ISR_BLOCK)
 	wdt_disable();
 }
 
-/** Initialises the hardware and software associated with the V2 protocol command handling. */
+/** Initializes the hardware and software associated with the V2 protocol command handling. */
 void V2Protocol_Init(void)
 {
 	#if defined(ADC)