From a09cb7e3d8d6256f5610459ee8dd80e0efd741f7 Mon Sep 17 00:00:00 2001 From: Dean Camera Date: Sun, 12 Oct 2014 16:43:30 +1100 Subject: Fix bootloaders not starting user application if the HWB is grounded during watchdog reset. --- Bootloaders/HID/BootloaderHID.txt | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) (limited to 'Bootloaders/HID/BootloaderHID.txt') diff --git a/Bootloaders/HID/BootloaderHID.txt b/Bootloaders/HID/BootloaderHID.txt index 63c1505cc..e340703c4 100644 --- a/Bootloaders/HID/BootloaderHID.txt +++ b/Bootloaders/HID/BootloaderHID.txt @@ -61,9 +61,9 @@ * * \section Sec_Running Running the Bootloader * - * This bootloader is designed to be started via the HWB mechanism of the USB AVRs; ground the HWB pin (see device - * datasheet) then momentarily ground /RESET to start the bootloader. This assumes the HWBE fuse is set and the BOOTRST - * fuse is cleared. + * This bootloader is designed to be started via the \c HWB mechanism of the USB AVRs; ground the \c HWB pin (see device + * datasheet) then momentarily ground \c /RESET to start the bootloader. This assumes the \c HWBE fuse is set and the + * \c BOOTRST fuse is cleared. * * \section Sec_Installation Driver Installation * @@ -73,7 +73,7 @@ * \section Sec_HostApp Host Controller Application * * Due to licensing issues, the supplied bootloader is compatible with the HalfKay bootloader protocol designed - * by PJRC, but is non-compatible with the cross-platform loader GUI. A modified version of the open source + * by PJRC, but is not compatible with the cross-platform loader GUI. A modified version of the open source * cross-platform TeensyLoader application is supplied, which can be compiled under most operating systems. The * command-line loader application should remain compatible with genuine Teensy boards in addition to boards using * this custom bootloader. @@ -86,9 +86,9 @@ * \section Sec_KnownIssues Known Issues: * * \par After loading an application, it is not run automatically on startup. - * Some USB AVR boards ship with the BOOTRST fuse set, causing the bootloader - * to run automatically when the device is reset. In most cases, the BOOTRST - * fuse should be disabled and the HWBE fuse used instead to run the bootloader + * Some USB AVR boards ship with the \c BOOTRST fuse set, causing the bootloader + * to run automatically when the device is reset. This booloader requires the + * \c BOOTRST be disabled and the HWBE fuse used instead to run the bootloader * when needed. * * \section SSec_Options Project Options -- cgit v1.2.3