/** \file * * This file contains special DoxyGen information for the generation of the main page and other special * documentation pages. It is not a project source file. */ /** \mainpage HID Class USB AVR Bootloader * * \section SSec_Compat Demo Compatibility: * * The following list indicates what microcontrollers are compatible with this demo. * * - Series 7 USB AVRs (AT90USBxxx7) * - Series 6 USB AVRs (AT90USBxxx6) * - Series 4 USB AVRs (ATMEGAxxU4) * - Series 2 USB AVRs (AT90USBxx2, ATMEGAxxU2) * * \section SSec_Info USB Information: * * The following table gives a rundown of the USB utilization of this demo. * * * * * * * * * * * * * * * * * * * * * * *
USB Mode:Device
USB Class:Human Interface Device Class (HID)
USB Subclass:N/A
Relevant Standards:USBIF HID Class Standard \n * Teensy Programming Protocol Specification
Usable Speeds:Low Speed Mode \n * Full Speed Mode
* * \section SSec_Description Project Description: * * This bootloader enumerates to the host as a HID Class device, allowing for device FLASH programming through * the supplied command line software, which is a modified version of Paul's TeensyHID Command Line loader code * from PJRC (used with permission). This bootloader is deliberatley non-compatible with the properietary PJRC * HalfKay bootloader GUI; only the command line interface software accompanying this bootloader will work with it. * * Out of the box this bootloader builds for the AT90USB1287, and will fit into 2KB of bootloader space for the * Series 2 USB AVRs (ATMEGAxxU2, AT90USBxx2) or 4KB of bootloader space for all other models. If you wish to * enlarge this space and/or change the AVR model, you will need to edit the MCU, FLASH_SIZE_KB and * BOOT_SECTION_SIZE_KB values in the accompanying makefile. * * \section Sec_Installation Driver Installation * * This bootloader uses the HID class driver inbuilt into all modern operating systems, thus no additional drivers * need to be supplied for correct operation. * * \section Sec_HostApp Host Controller Application * * Due to licensing issues, the supplied bootloader is compatible with the HalfKay bootloader protocol designed * by PJRC, but is non-compatible with the cross-platform loader GUI. A modified version of the open source * cross-platform TeensyLoader application is supplied, which can be compiled under most operating systems. The * command-line loader application should remain compatible with genuine Teensy boards in addition to boards using * this custom bootloader. * * Once compiled, programs can be loaded into the AVR's FLASH memory through the following example command: * \code * hid_bootloader_cli -mmcu=at90usb1287 Mouse.hex * \endcode * * \section SSec_Options Project Options * * The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value. * * * * * *
* None *
*/