From e7fdd6e9a17129da53b8f4104b58899b5a011458 Mon Sep 17 00:00:00 2001 From: Carl-Daniel Hailfinger Date: Wed, 21 Jul 2010 10:26:01 +0000 Subject: Add support for RayeR SPIPGM hardware as described in http://rayer.ic.cz/elektro/spipgm.htm To use the RayeR driver, run flashrom -p rayer_spi -V Known bugs/limitations: - Won't compile/work on non-x86 architectures. - Will always use direct port I/O access. Log follows: flashrom v0.9.2-r1039 on MS-DOS 7 (i686), built with libpci 3.1.5, GCC 4.3.2, little endian Calibrating delay loop... OK. Initializing rayer_bitbang_spi programmer Using port 0x378 as I/O base for parallel port access. ... Probing for Macronix MX25L1605, 2048 KB: probe_spi_rdid_generic: id1 0xc2, id2 0x2015 ... Found chip "Macronix MX25L1605" (2048 KB, SPI) at physical address 0xffe00000. ... No operations were specified. Corresponding to flashrom svn r1093. Signed-off-by: Carl-Daniel Hailfinger Acked-by: Martin Rehak Acked-by: Michael Karcher --- Makefile | 16 +++++++++++++++- 1 file changed, 15 insertions(+), 1 deletion(-) (limited to 'Makefile') diff --git a/Makefile b/Makefile index 96de0ae2..290b9e63 100644 --- a/Makefile +++ b/Makefile @@ -111,8 +111,15 @@ CONFIG_INTERNAL ?= yes # Always enable serprog for now. Needs to be disabled on Windows. CONFIG_SERPROG ?= yes -# Bitbanging SPI infrastructure is not used yet. +# RayeR SPIPGM hardware support +CONFIG_RAYER_SPI ?= yes + +# Bitbanging SPI infrastructure, default off unless needed. +ifeq ($(CONFIG_RAYER_SPI), yes) +override CONFIG_BITBANG_SPI = yes +else CONFIG_BITBANG_SPI ?= no +endif # Always enable 3Com NICs for now. CONFIG_NIC3COM ?= yes @@ -166,6 +173,13 @@ NEED_SERIAL := yes NEED_NET := yes endif +ifeq ($(CONFIG_RAYER_SPI), yes) +FEATURE_CFLAGS += -D'CONFIG_RAYER_SPI=1' +PROGRAMMER_OBJS += rayer_spi.o +# Actually, NEED_PCI is wrong. NEED_IOPORT_ACCESS would be more correct. +NEED_PCI := yes +endif + ifeq ($(CONFIG_BITBANG_SPI), yes) FEATURE_CFLAGS += -D'CONFIG_BITBANG_SPI=1' PROGRAMMER_OBJS += bitbang_spi.o -- cgit v1.2.3