From 9621d872ca496eadb79399d0351abf96abc35338 Mon Sep 17 00:00:00 2001 From: Felix Fietkau Date: Sun, 15 Jun 2008 11:10:13 +0000 Subject: (3/6) bcm57xx: preinit This patch allows the bcm57xx module to work correctly with failsafe mode. insmod doesn't return an error when a module loads but doesn't detect a switch. I added the check_module function to load the module, then make sure it doesn't just exit immediately. This allows preinit to only attempt to load the bcm57xx module when switch-robo and switch-adm dont detect a switch. The activate_gpio parameter to bcm57xx simply instructs the module to attempt to activate the switch via gpio before probing for the switch. Tested on wrt350n. Signed-off-by: Ben Pfountz SVN-Revision: 11468 --- target/linux/brcm-2.4/base-files/etc/preinit.arch | 17 ++++++++++++++--- 1 file changed, 14 insertions(+), 3 deletions(-) (limited to 'target/linux') diff --git a/target/linux/brcm-2.4/base-files/etc/preinit.arch b/target/linux/brcm-2.4/base-files/etc/preinit.arch index 5127e6088b..1b3c924ced 100755 --- a/target/linux/brcm-2.4/base-files/etc/preinit.arch +++ b/target/linux/brcm-2.4/base-files/etc/preinit.arch @@ -4,7 +4,7 @@ failsafe() { lock /tmp/.failsafe failsafe_ip - echo "0 1 2 3 4 5u*" > /proc/switch/eth0/vlan/0/ports + echo "0 1 2 3 4 ${cpu_port:-5u*}" > /proc/switch/eth0/vlan/0/ports set_state failsafe [ -x "/usr/sbin/nvram" ] && { @@ -39,8 +39,19 @@ esac failsafe_ip +check_module () { + module="$1"; shift; params="$*" + + insmod "$module" "$params" + sleep 1 + grep "^$module" /proc/modules + return $? +} + insmod switch-core -insmod switch-robo || insmod switch-adm || rmmod switch-core +check_module switch-robo || check_module switch-adm || { + check_module bcm57xx activate_gpio=0x4 && cpu_port="8u*" +} || rmmod switch-core [ -d /proc/switch/eth0 ] && { echo 1 > /proc/switch/eth0/reset @@ -48,7 +59,7 @@ insmod switch-robo || insmod switch-adm || rmmod switch-core # this would be easier if we blasted the message across all ports # but we don't want packets leaking across interfaces for port in $(seq 0 4); do { - echo "$port 5u*" > /proc/switch/eth0/vlan/0/ports + echo "$port ${cpu_port:-5u*}" > /proc/switch/eth0/vlan/0/ports netmsg 192.168.1.255 "Press reset now, to enter Failsafe!" }; done } || netmsg 192.168.1.255 "Press reset now, to enter Failsafe!" -- cgit v1.2.3