aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/x86/net5501
Commit message (Collapse)AuthorAgeFilesLines
* build: unify x86 target cflagsFelix Fietkau2013-09-261-2/+1
| | | | | | Signed-off-by: Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@38212 3c298f89-4303-0410-b956-a3cf2f4a3e73
* target: don't build jffs2 nor images by defaultJonas Gorski2013-06-051-1/+1
| | | | | | Signed-off-by: Jonas Gorski <jogo@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36863 3c298f89-4303-0410-b956-a3cf2f4a3e73
* Change default IPv6 config to enable DHCPv6-PDSteven Barth2013-04-221-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36384 3c298f89-4303-0410-b956-a3cf2f4a3e73
* Adapt default network configuration for IPv6Steven Barth2013-04-091-0/+8
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36278 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: fix typo in alix2/net5501 default packagesFelix Fietkau2013-01-021-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@34972 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: remove support for old kernelsGabor Juhos2012-05-181-20/+0
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31804 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: remove subtarget specific LINUX_VERSION overridesGabor Juhos2012-05-181-1/+0
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31803 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86/net5501: switch to 3.3Gabor Juhos2012-05-162-1/+20
| | | | | | Compile tested only. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31752 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: sync 3.2 configsGabor Juhos2012-05-161-2/+5
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31750 3c298f89-4303-0410-b956-a3cf2f4a3e73
* linux: move certain disabled symbols to the generic configsGabor Juhos2012-05-151-7/+0
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | * CONFIG_ARCH_DMA_ADDR_T_64BIT * CONFIG_ARCH_HAS_ILOG2_U32 * CONFIG_ARCH_HAS_ILOG2_U64 * CONFIG_ARCH_PHYS_ADDR_T_64BIT * CONFIG_ARCH_SUPPORTS_MSI * CONFIG_GENERIC_CPU_DEVICES * CONFIG_HWMON_DEBUG_CHIP * CONFIG_I2C_PXA_PCI * CONFIG_LEDS_GPIO * CONFIG_MINIX_FS_NATIVE_ENDIAN * CONFIG_MLX4_CORE * CONFIG_POWER_SUPPLY * CONFIG_POWER_SUPPLY_DEBUG * CONFIG_QUOTACTL * CONFIG_SDIO_UART * CONFIG_SENSORS_K10TEMP * CONFIG_SENSORS_SCH56XX_COMMON * CONFIG_SENSORS_VIA_CPUTEMP * CONFIG_SERIO_AMBAKMI * CONFIG_SERIO_I8042 * CONFIG_SERIO_LIBPS2 * CONFIG_SERIO_PCIPS2 * CONFIG_SERIO_RAW * CONFIG_SERIO_SERPORT * CONFIG_SPI_BITBANG * CONFIG_SPI_GPIO git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31737 3c298f89-4303-0410-b956-a3cf2f4a3e73
* kernel: update linux 3.2 to 3.2.16Jonas Gorski2012-04-241-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31459 3c298f89-4303-0410-b956-a3cf2f4a3e73
* kernel: x86: also update subtarget kernel versionsJonas Gorski2012-04-171-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@31338 3c298f89-4303-0410-b956-a3cf2f4a3e73
* config: deprecated symbol CONFIG_LEDS_GPIO_PLATFORMJo-Philipp Wich2012-02-241-1/+0
| | | | | | | | | | | | CONFIG_LEDS_GPIO_PLATFORM went away a while ago. http://git.kernel.org/?p=linux/kernel/git/stable/linux-stable.git;a=commit;h=2bcc7ed5b83b0a59c6976476e8788675038fb11b Also, most platforms comment out CONFIG_LEDS_GPIO but not x86 for some reason. Signed-off-by: Philip Prindeville <philipp@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@30708 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [PATCHv2 1/1] net5501: backport drivers from linux-nextJo-Philipp Wich2012-02-031-1/+1
| | | | | | | | | Backport net5501 platform driver from 3.4. Remove vestiges of old (pre-2.6.30) leds-net5501.c driver. Signed-off-by: Philip Prindeville <philipp@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@30021 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] net5501: adjust CFLAGS and package selection (#10893)Jo-Philipp Wich2012-02-031-3/+3
| | | | | | | This patches the CFLAGS for Geode LX CPUs for 4.3 and new GGC versions. This creates more compatible code and allowed me to boot my system first time with no troubles. Also, the missing kmod is added in. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@30013 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] alix2, geos, net5501: remove kmod-ledtrig-netfilter, its not used by ↵Jo-Philipp Wich2012-02-021-1/+1
| | | | | | any standard system facility git-svn-id: svn://svn.openwrt.org/openwrt/trunk@30000 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] alix2, goes, net5501: clean up default packagesJo-Philipp Wich2012-02-021-3/+1
| | | | | | | | | | | Remove packages which are dependencies of other packages Remove packages which are part of the default package list Remove DSL specific packages from net5501 Remove bridge package, we use the busybox applet Replace hostapd with wpad git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29999 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] alix2, net5501: bump both subtargets to Linux 3.2.2 to align with the restJo-Philipp Wich2012-02-021-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29998 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [PATCH] net5501: correct net5501 h/w configurationJo-Philipp Wich2012-02-025-36/+86
| | | | | | | | | | | | | | | | | Bump to version 3.2. Simplify and correct kernel config (based on x86/config-3.2). Designate eth0 as wan interface, and bridge eth1/eth2/eth3. Add heartbeat LED trigger. Use correct CS5535 GPIO driver. Use correct USB drivers (OHCI not UHCI). Add MSR and HW clock support. Add GPIO mask definition. Add correct SATA drivers. Add LED triggers. [Patch from Philipp Prindeville, via http://patchwork.openwrt.org/patch/1802/] git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29994 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: turn off CONFIG_X86_GENERIC for geos and net5501Felix Fietkau2010-11-211-2/+3
| | | | | | | | CONFIG_X86_GENERIC obscures CONFIG_MGEODE_LX, etc. and causes it to use wrong cache-line size. Signed-off-by: Philip Prindeville <philipp@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@24071 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: refresh config, enable pci express supportFelix Fietkau2010-11-171-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@24026 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] net5501: Add features to net5501 and remove HID support (unneeded)Florian Fainelli2010-11-071-1/+2
| | | | | | | | | | | Since the net5501 doesn't have a VGA port, it doesn't need HID support either -- all console access will be over a serial port. Also add FEATURES to it as well. Signed-of-by: Philip Prindeville <philip@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23916 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [package] add kmod-leds-net5501Florian Fainelli2010-10-301-1/+1
| | | | | | Signed-off-by: Philip Prindeville <philipp_subx@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23729 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] resync config-default, enable gpio supportFlorian Fainelli2010-10-301-10/+25
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23727 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] Use -pipe for net5501 and geos CFLAGS, same as all of the other platformsFlorian Fainelli2010-10-171-1/+2
| | | | | | | | Makes the builds run slightly faster on multicores. Signed-off-by: Philip Prindeville <philipp@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23495 3c298f89-4303-0410-b956-a3cf2f4a3e73
* x86: turn on optimizations for net5501 (patch by Philip A. Prindeville)Felix Fietkau2010-09-201-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23104 3c298f89-4303-0410-b956-a3cf2f4a3e73
* package/kernel: use common gpio- & wdt- prefixes for GPIO and watchdog ↵Nicolas Thill2010-04-241-2/+2
| | | | | | module names git-svn-id: svn://svn.openwrt.org/openwrt/trunk@21137 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [x86] add net5501 supportFlorian Fainelli2010-04-112-0/+40
This patch brings up the net5501 platform. Note that the x86/ target included support for all x86/ class processors. That's not technically correct. This should be constrained only to the "generic" subtarget. Every x86-class target that isn't generic should be able to select only the optimizations/capabilities applicable to that architectural variant. It's also assumed that all x86 processors have keyboard & mouse ports, ISA, DMI, ACPI... the embedded ones typically don't. Again, moving that to the generic subtarget. Fortunately, this was a fairly benign tweak. The net5501 board includes the following logic: Geode/LX processor CS5535 super-I/O chip PC87360 sensor chip Via Rhine Ethernet controllers Via Sata controllers USB, LEDS, I2C Signed-off-by: Philip Prindeville <philipp_subx@redfish-solutions.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20794 3c298f89-4303-0410-b956-a3cf2f4a3e73
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-01 17:59:48 +0000