diff options
| author | Ryan Mounce <ryan@mounce.com.au> | 2021-11-16 21:55:19 +1030 |
|---|---|---|
| committer | Christian Lamparter <chunkeey@gmail.com> | 2021-12-11 00:50:02 +0100 |
| commit | 35aecc9d4a735c36d5eefe6e821c5930f736635f (patch) | |
| tree | 170c0a3a0b9b4f8f05d686f2fd2152b59ceb1cfd /target/linux/ath79/generic/base-files/etc/board.d/02_network | |
| parent | 7853453950bf47b518673dc50b61903cd48c9081 (diff) | |
| download | upstream-35aecc9d4a735c36d5eefe6e821c5930f736635f.tar.gz upstream-35aecc9d4a735c36d5eefe6e821c5930f736635f.tar.bz2 upstream-35aecc9d4a735c36d5eefe6e821c5930f736635f.zip | |
ath79: add support for WD My Net N600
SoC: AR9344
RAM: 128MB
Flash: 16MiB SPI NOR
5GHz WiFi: AR9382 PCIe 2x2:2 802.11n
2.4GHz WiFi: AR9344 (SoC) AHB 2x2:2 802.11n
5x Fast ethernet via SoC switch (green LEDs)
1x USB 2.0
4x front LEDs from SoC GPIO
1x front WPS button from SoC GPIO
1x bottom reset button from SoC GPIO
UART header JP1, 115200 no parity 1 stop
TX
GND
VCC
(N/P)
RX
Flash factory image via "emergency room" recovery:
- Configure your computer with a static IP 192.168.1.123/24
- Connect to LAN port on the N600 switch
- Hold reset putton
- Power on, holding reset until the power LED blinks slowly
- Visit http://192.168.1.1/ and upload OpenWrt factory image
- Wait at least 5 minutes for flashing, reboot and key generation
- Visit http://192.168.1.1/ (OpenWrt LuCI) and upload OpenWrt sysupgrade image
Signed-off-by: Ryan Mounce <ryan@mounce.com.au>
[dt leds preparations]
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
Diffstat (limited to 'target/linux/ath79/generic/base-files/etc/board.d/02_network')
| -rw-r--r-- | target/linux/ath79/generic/base-files/etc/board.d/02_network | 4 |
1 files changed, 3 insertions, 1 deletions
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 45b002330e..edd79b606e 100644 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -130,7 +130,8 @@ ath79_setup_interfaces() pcs,cr3000|\ tplink,archer-c58-v1|\ tplink,archer-c59-v1|\ - tplink,archer-c59-v2) + tplink,archer-c59-v2|\ + wd,mynet-n600) ucidef_set_interface_wan "eth1" ucidef_add_switch "switch0" \ "0@eth0" "1:lan:1" "2:lan:4" "3:lan:3" "4:lan:2" @@ -595,6 +596,7 @@ ath79_setup_macs() ;; dlink,dir-859-a1|\ qihoo,c301|\ + wd,mynet-n600|\ wd,mynet-n750) lan_mac=$(mtd_get_mac_ascii devdata "lanmac") wan_mac=$(mtd_get_mac_ascii devdata "wanmac") |