diff options
Diffstat (limited to 'target/linux/kirkwood/files-5.4/arch/arm')
| -rw-r--r-- | target/linux/kirkwood/files-5.4/arch/arm/boot/dts/kirkwood-linksys-audi.dts | 71 |
1 files changed, 53 insertions, 18 deletions
diff --git a/target/linux/kirkwood/files-5.4/arch/arm/boot/dts/kirkwood-linksys-audi.dts b/target/linux/kirkwood/files-5.4/arch/arm/boot/dts/kirkwood-linksys-audi.dts index eff9102d33..90250fefc8 100644 --- a/target/linux/kirkwood/files-5.4/arch/arm/boot/dts/kirkwood-linksys-audi.dts +++ b/target/linux/kirkwood/files-5.4/arch/arm/boot/dts/kirkwood-linksys-audi.dts @@ -66,17 +66,6 @@ default-state = "on"; }; }; - - mvsw61xx { - compatible = "marvell,88e6171"; - status = "okay"; - reg = <0x10>; - - mii-bus = <&mdio>; - cpu-port-0 = <5>; - cpu-port-1 = <6>; - is-indirect; - }; }; &pinctrl { @@ -96,6 +85,57 @@ }; }; +&mdio { + status = "okay"; + + switch@10 { + compatible = "marvell,mv88e6085"; + #address-cells = <1>; + #size-cells = <0>; + reg = <16>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + label = "ethernet1"; + }; + + port@1 { + reg = <1>; + label = "ethernet2"; + }; + + port@2 { + reg = <2>; + label = "ethernet3"; + }; + + port@3 { + reg = <3>; + label = "ethernet4"; + }; + + port@4 { + reg = <4>; + label = "internet"; + }; + + port@5 { + reg = <5>; + label = "cpu"; + ethernet = <ð0port>; + fixed-link { + speed = <1000>; + full-duplex; + }; + }; + }; + }; +}; + &nand { status = "okay"; @@ -188,15 +228,10 @@ }; /* eth1 is connected to the switch at port 6. However DSA only supports a - * single CPU port. Upstream uses DSA so they disable this port to avoid confusion. + * single CPU port. This port is disabled to avoid confusion. */ ð1 { - status = "okay"; - - ethernet1-port@0 { - speed = <1000>; - duplex = <1>; - }; + status = "disabled"; }; /* There is no battery on the board, so the RTC does not keep |