aboutsummaryrefslogtreecommitdiffstats
Commit message (Collapse)AuthorAgeFilesLines
* gspca-sn9c20x.ko was not insmod'ed due to typoJohn Crispin2012-08-041-1/+1
| | | | | | fixes #11973 SVN-Revision: 32991
* wrt55agv2-spidevs needs <linux/modules.h>John Crispin2012-08-031-0/+1
| | | | SVN-Revision: 32956
* cleanup patchesJohn Crispin2012-08-03209-82080/+146978
| | | | SVN-Revision: 32953
* nuport-mac: properly protect the phy interrupt handlerFlorian Fainelli2012-08-021-2/+8
| | | | SVN-Revision: 32951
* Codel: avoid a nul rec_inv_sqrtJohn Crispin2012-08-021-0/+68
| | | | | | | | | | | | | | | One condition before codel_Newton_step() was not good if we never left the dropping state for a flow. As a result rec_inv_sqrt was 0, instead of the ~0 initial value. codel control law was then set to a very aggressive mode, dropping many packets before reaching 'target' and recovering from this problem. Brought over from 3.5-stable Signed-off-by: Dave Taht <dave.taht@bufferbloat.net> SVN-Revision: 32950
* fixes i2c clock enableJohn Crispin2012-08-021-0/+32
| | | | SVN-Revision: 32949
* ar71xx: simplify misc IRQ handlingGabor Juhos2012-08-021-0/+66
| | | | SVN-Revision: 32948
* ar71xx: fix AR934X_EHCI_SIZEGabor Juhos2012-08-024-4/+4
| | | | SVN-Revision: 32947
* ar71xx: image: stop the switch from the lzma-loader on the TL-WR1043NDGabor Juhos2012-08-022-0/+745
| | | | SVN-Revision: 32946
* ar71xx: image: allow to use board specific code in the lzma-loaderGabor Juhos2012-08-023-3/+10
| | | | SVN-Revision: 32945
* ar71xx: init switch hw_reset on the TL-WR1043ND boardGabor Juhos2012-08-021-2/+15
| | | | SVN-Revision: 32944
* generic: rtl836x: add hw_reset field to struct rtl8366_smiGabor Juhos2012-08-027-2/+35
| | | | | | | It will be used to start/stop the switch if that is supported by the given board. SVN-Revision: 32943
* generic: rtl8366_smi: use __rtl8366_smi_cleanup instead of gpio_free callsGabor Juhos2012-08-021-2/+1
| | | | SVN-Revision: 32942
* add missing netmask to the network configFlorian Fainelli2012-08-011-0/+1
| | | | SVN-Revision: 32941
* assume the link is up and full-duplex by defaultFlorian Fainelli2012-08-011-2/+2
| | | | SVN-Revision: 32940
* add a default and suitable network config fileFlorian Fainelli2012-08-011-0/+12
| | | | SVN-Revision: 32939
* ar71xx: ew-dorin: added router firmware generationGabor Juhos2012-08-016-5/+49
| | | | | | | | [juhosg: remove dead code] Signed-off-by: embedded wireless GmbH <info@embeddedwireless.de> SVN-Revision: 32934
* ar71xx: ew-dorin: added USB supportGabor Juhos2012-08-011-1/+3
| | | | | | Signed-off-by: embedded wireless GmbH <info@embeddedwireless.de> SVN-Revision: 32933
* ar71xx: Buffalo WLAE-AG300N wireless led patchGabor Juhos2012-08-011-0/+4
| | | | | | | | | Here is the uci-defaults version of the led support for the Buffalo WLAE-AG300N. Signed-off-by: Yoichi Shinoda <shinoda@jaist.ac.jp> SVN-Revision: 32932
* ar71xx: Buffalo WLAE-AG300N initial supportGabor Juhos2012-08-018-7/+156
| | | | | | | | | | | | | | | | | | | | The patch set for Buffalo WLAE-AG300N initial support. There is another patch for wireless led support that is posted separately. Note on serial console: This unit has buffalo standard 4 pin console, but the unit may not power on if some console apparatus is connected. This is probably due to some electronic interaction between the unit's electronic power switch circuit and the serial console apparatus. If this happens, it is required to power on the unit without the console, then quickly (re-)attach it. [juhosg: fix coding style] Signed-off-by: Yoichi Shinoda <shinoda@jaist.ac.jp> SVN-Revision: 32931
* resync defconfig enable XZ compressionFlorian Fainelli2012-08-011-7/+1
| | | | SVN-Revision: 32930
* uclibc++: update to 0.2.4Florian Fainelli2012-08-017-205/+19
| | | | SVN-Revision: 32929
* uclibc++: stage g++-uc wrappers in $(TOOLCHAIN_DIR)Florian Fainelli2012-08-011-7/+7
| | | | | | | Since we are overriding TARGET_CXX with the g++-uc wrapper when we use cmake it expects to find g++-uc in the TOOLCHAIN_DIR. SVN-Revision: 32928
* properly generate squashfs, jffs2 and initramfs images and kernelsFlorian Fainelli2012-07-312-16/+9
| | | | SVN-Revision: 32927
* disable crashlog on ARM platforms for the momentFlorian Fainelli2012-07-311-1/+1
| | | | | | It is currently badly broken on ARM, until fixed, disable it SVN-Revision: 32926
* add lantiq svip supportJohn Crispin2012-07-3122-53/+17723
| | | | SVN-Revision: 32925
* bcm63xx: Add nb6 support (BCM6362 SoC base boards)Jonas Gorski2012-07-3110-6/+191
| | | | | | | | | Signed-off-by: Miguel GAIO <miguel.gaio@efixo.com> Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com> [jonas.gorski@gmail.com: add network config for nb6, make switch fix a platform patch] SVN-Revision: 32924
* bcm63xx: add basic bcm6362 supportJonas Gorski2012-07-3118-14/+1008
| | | | | | Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com> SVN-Revision: 32923
* bcm63xx: enable usb for bcm6328Jonas Gorski2012-07-311-0/+60
| | | | | | Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com> SVN-Revision: 32922
* bcm63xx: update enetswitch driverJonas Gorski2012-07-3131-44/+452
| | | | | | | | Update enetswith driver with latest fixes and additions. Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com> SVN-Revision: 32921
* bcm63xx: reorder patchesJonas Gorski2012-07-3113-17/+17
| | | | | | | | Fix the order and names of patches. Signed-off-by: Jonas Gorski <jonas.gorski+openwrt@gmail.com> SVN-Revision: 32920
* move i2c module to target modules.mkFlorian Fainelli2012-07-291-0/+17
| | | | SVN-Revision: 32910
* partially revert r32855Florian Fainelli2012-07-291-0/+114
| | | | | | | Too many modules were removed, while only the octeon module was meant to be removed, fix that. SVN-Revision: 32909
* resync configFlorian Fainelli2012-07-291-20/+0
| | | | SVN-Revision: 32908
* use the same description as other omap platforms (without the dash)Florian Fainelli2012-07-291-1/+1
| | | | SVN-Revision: 32907
* refresh pwm patchJohn Crispin2012-07-291-9/+5
| | | | SVN-Revision: 32905
* dont build on arm as kernel headers are missing/have a different layoutJohn Crispin2012-07-291-1/+1
| | | | SVN-Revision: 32904
* fix up scons vs ccacheJohn Crispin2012-07-282-8/+9
| | | | SVN-Revision: 32902
* clean up pwm patches and driversJohn Crispin2012-07-289-885/+28
| | | | SVN-Revision: 32901
* add config option CONFIG_I2C_MV64XXX to fix kirkwood buildHauke Mehrtens2012-07-281-0/+1
| | | | SVN-Revision: 32898
* resync configFlorian Fainelli2012-07-271-4/+0
| | | | SVN-Revision: 32895
* fix DVA-G3810BN image generationFlorian Fainelli2012-07-271-1/+1
| | | | | | | | | Attached patch fixes a typo in the image Makefile, and overrides the board name for DVA-G3810BN to set the correct board properties Signed-Off-By: Jeroen van Bemmel <jbemmel@zonnet.nl> SVN-Revision: 32894
* add D-link DVA-G3810BN-TL-1 supportFlorian Fainelli2012-07-272-2/+84
| | | | | | Signed-Off-By: Jeroen van Bemmel <jbemmel@zonnet.nl> SVN-Revision: 32893
* Add CT6376-1 board supportFlorian Fainelli2012-07-275-2/+142
| | | | | | | | Added CT6373 devices instead of using NB4's devices, as Florian suggested. Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com> SVN-Revision: 32892
* base-files: fix detection of standalone lddFlorian Fainelli2012-07-272-2/+2
| | | | | | | | When standalone ldd is selected in config the binary is installed in /usr/bin/ldd. Signed-off-by: Michael Heimpold <mhei@heimpold.de> SVN-Revision: 32891
* Add brcmsmac profileFlorian Fainelli2012-07-271-0/+17
| | | | | | | | Add brcmsmac profile (kmod-brcmsmac + wpad-mini). Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com> SVN-Revision: 32890
* mae brcmutil depend on PCI and USB. This broke ar7 fullbuildsJohn Crispin2012-07-271-0/+1
| | | | SVN-Revision: 32886
* Add leds back after migration to sysfsJohn Crispin2012-07-262-0/+12
| | | | | | | | | | atheros trunk moved to full sysfs gpiolib, but the leds were forgotten. This restores the wlan led that was missing after switching from backfire to trunk. Signed-off-by: Karl Palsson <karlp@remake.is> SVN-Revision: 32885
* add more missing config symbolsFlorian Fainelli2012-07-261-10/+13
| | | | SVN-Revision: 32884
* add more USB-related config symbolsFlorian Fainelli2012-07-261-0/+20
| | | | SVN-Revision: 32883
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-02 08:31:08 +0000