From 796ad2f7ef6fefcf821a3b21cadfdb7ef3126e95 Mon Sep 17 00:00:00 2001 From: Perry Melange Date: Wed, 7 Aug 2019 19:25:13 +0200 Subject: ath79: add support for D-Link DIR-842 C3 Hardware spec of DIR-842 C3: SoC: QCA9563 DRAM: 128MB DDR2 Flash: 16MB SPI-NOR Switch: QCA8337N WiFi 5.8GHz: QCA9888 WiFi 2.4Ghz: QCA9563 USB: circuit onboard, but components are not soldered Flash instructions: 1. Upgrade the factory.bin through the factory web interface or the u-boot failsafe interface. The firmware will boot up correctly for the first time. Do not power off the device after OpenWrt has booted. Otherwise the u-boot will enter failsafe mode as the checksum of the firmware has been changed. 2. Upgrade the sysupgrade.bin in OpenWrt. After upgrading completes the u-boot won't complain about the firmware checksum and it's OK to use now. 3. If you powered off the device before upgrading the sysupgrade.bin, just upgrade the factory.bin through the u-boot failsafe interface and then goto step 2. Signed-off-by: Perry Melange --- target/linux/ath79/base-files/etc/board.d/01_leds | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ath79/base-files/etc/board.d/01_leds') diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index 35cb74db28..aad41b0dad 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -64,6 +64,7 @@ comfast,cf-e5) ;; dlink,dir-842-c1|\ dlink,dir-842-c2|\ +dlink,dir-842-c3|\ dlink,dir-859-a1) ucidef_set_led_switch "internet" "WAN" "$boardname:green:internet" "switch0" "0x20" ;; -- cgit v1.2.3