From 8d68be8057d6c689025cc236d20b96b77a6ccf30 Mon Sep 17 00:00:00 2001 From: David Bauer Date: Tue, 1 Jan 2019 19:17:22 +0100 Subject: ath79: add support for devolo WiFi pro 1750i Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) WiFi2: QCA9558 3T3R WiFi5: QCA9880 3T3R BTN: 1x Reset LED: 1x LED blue 1x LED red BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad) Header is located next to reset-button Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password the one set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: David Bauer --- target/linux/ath79/base-files/etc/board.d/02_network | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ath79/base-files/etc/board.d/02_network') diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 97d1390106..0b1a5f39a1 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -11,6 +11,7 @@ ath79_setup_interfaces() case "$board" in avm,fritz300e|\ devolo,dvl1750c|\ + devolo,dvl1750i|\ ocedo,koala|\ ocedo,raccoon|\ pcs,cap324|\ -- cgit v1.2.3