From e67da3443168fa6b6727cd81a35d559be77d6b4c Mon Sep 17 00:00:00 2001 From: David Bauer Date: Thu, 27 Dec 2018 02:32:39 +0100 Subject: ath79: add support for devolo WiFi pro 1750c Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) WiFi2: QCA9558 3T3R WiFi5: QCA9880 3T3R BTN: 1x Reset LED: 1x LED blue 1x LED red BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad) Header is located next to reset-button There is also a Micro-B USB-port present but this only seems to be a dummy as the circuit next to it is not present (at least in my unit). It is also not mentioned in the devolo manual. Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password the one set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: David Bauer --- target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts | 46 ++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts (limited to 'target/linux/ath79/dts') diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts b/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts new file mode 100644 index 0000000000..b5a2954406 --- /dev/null +++ b/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts @@ -0,0 +1,46 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca9558_devolo_dvl1xxx.dtsi" + +/ { + compatible = "devolo,dvl1750c", "qca,qca9557"; + model = "devolo WiFi pro 1750c"; + + aliases { + led-boot = &status_blue; + led-failsafe = &status_red; + led-running = &status_blue; + led-upgrade = &status_red; + }; + + leds { + compatible = "gpio-leds"; + + status_blue: status_blue { + label = "dvl1750c:blue:status"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + status_red: status_red { + label = "dvl1750c:red:status"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + }; + + beeper { + compatible = "gpio-beeper"; + gpios = <&gpio 21 GPIO_ACTIVE_HIGH>; + }; +}; + +&gmac_config { + rxdv-delay = <3>; + rxd-delay = <3>; + txen-delay = <3>; + txd-delay = <3>; +}; -- cgit v1.2.3