From 1724d4e9ed7716a5444eca42adf045c2f3afc554 Mon Sep 17 00:00:00 2001 From: David Bauer Date: Thu, 27 Dec 2018 02:32:38 +0100 Subject: ath79: add support for devolo WiFi pro 1200e Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) 1x Atheros AR8033 WiFi2: QCA9558 2T2R WiFi5: QCA9880 2T2R BTN: 1x Reset LED: 1x LED blue 1x LED red BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad) Header is located next to reset-button Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password the one set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: David Bauer --- target/linux/ath79/generic/config-default | 3 +++ 1 file changed, 3 insertions(+) (limited to 'target/linux/ath79/generic') diff --git a/target/linux/ath79/generic/config-default b/target/linux/ath79/generic/config-default index b2194a4132..fddcb1d704 100644 --- a/target/linux/ath79/generic/config-default +++ b/target/linux/ath79/generic/config-default @@ -1,5 +1,7 @@ CONFIG_AT803X_PHY=y CONFIG_BLK_MQ_PCI=y +CONFIG_GPIO_WATCHDOG=y +CONFIG_GPIO_WATCHDOG_ARCH_INITCALL=y CONFIG_INTEL_XWAY_PHY=y CONFIG_IP17XX_PHY=y CONFIG_LEDS_RESET=y @@ -23,3 +25,4 @@ CONFIG_RTL8366RB_PHY=y CONFIG_RTL8366S_PHY=y CONFIG_RTL8366_SMI=y CONFIG_RTL8367_PHY=y +CONFIG_WATCHDOG_CORE=y -- cgit v1.2.3