From 5b8709d9f251c8ce1a0c8e1444ab0be4b4a4de21 Mon Sep 17 00:00:00 2001 From: Andrew Cameron Date: Wed, 6 Nov 2019 20:12:55 -0600 Subject: ath79: add support for the TP-LINK WBS510 V2 This adds support for a popular low-cost 5GHz N based AP Specifications: - SoC: Atheros AR9344 - RAM: 64MB - Storage: 8 MB SPI NOR - Wireless: 5GHz 300 Mbps, 2x RP-SMA connector, 27 dBm TX power - Ethernet: 1x 10/100 Mbps with 24V POE IN, 1x 10/100 Mbps Installation: Flash factory image through stock firmware WEB UI or through TFTP To get to TFTP recovery just hold reset button while powering on for around 4-5 seconds and release. Rename factory image to recovery.bin Stock TFTP server IP:192.168.0.100 Stock device TFTP adress:192.168.0.254 Signed-off-by: Andrew Cameron --- target/linux/ath79/generic/base-files/etc/board.d/01_leds | 3 ++- target/linux/ath79/generic/base-files/etc/board.d/02_network | 1 + target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches | 3 ++- 3 files changed, 5 insertions(+), 2 deletions(-) (limited to 'target/linux/ath79/generic') diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index d54e770240..5bb1d92a60 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -175,7 +175,8 @@ tplink,cpe210-v1|\ tplink,cpe220-v2|\ tplink,cpe220-v3|\ tplink,cpe510-v1|\ -tplink,wbs210-v2) +tplink,wbs210-v2|\ +tplink,wbs510-v2) ucidef_set_led_netdev "lan0" "LAN0" "tp-link:green:lan0" "eth1" ucidef_set_led_switch "lan1" "LAN1" "tp-link:green:lan1" "switch0" "0x10" ucidef_set_rssimon "wlan0" "200000" "1" diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 07f3c4e83c..dcc0b8be23 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -92,6 +92,7 @@ ath79_setup_interfaces() tplink,cpe220-v3|\ tplink,cpe510-v1|\ tplink,wbs210-v2|\ + tplink,wbs510-v2|\ ubnt,nanostation-m|\ ubnt,routerstation) ucidef_set_interfaces_lan_wan "eth1" "eth0" diff --git a/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches b/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches index 9bce6cc51b..844b212152 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches +++ b/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches @@ -46,7 +46,8 @@ tplink,cpe210-v1|\ tplink,cpe220-v2|\ tplink,cpe220-v3|\ tplink,cpe510-v1|\ -tplink,wbs210-v2) +tplink,wbs210-v2|\ +tplink,wbs510-v2) ucidef_add_gpio_switch "poe_passthrough" "PoE Passthrough" "20" ;; ubnt,nanostation-ac) -- cgit v1.2.3