From 0070650df45da29a55a89922544dba6859c18f2b Mon Sep 17 00:00:00 2001 From: Michael Pratt Date: Fri, 1 Jan 2021 16:48:52 -0500 Subject: ath79: move small-flash Engenius boards to tiny This moves some of the Engenius boards from generic to tiny: - EAP350 v1 - ECB350 v1 - ENH202 v1 For these, factory.bin builds are already failing on master branch because of the unique situation for these boards: - 8 MB flash - an extra "failsafe" image for recovery - TFTP does not work (barely possible with 600 MTU) - bootloader loads image from a longer flash offset - 1 eraseblock each needed for OKLI kernel loader and fake rootfs - using mtd-concat to make use of remaining space... The manual alternative would be removing the failsafe partition. However this comes with the risk of extremely difficult recovery if a flash ever fails because TFTP on the bootloader is bugged. Signed-off-by: Michael Pratt [improve commit message] Signed-off-by: Adrian Schmutzler --- target/linux/ath79/tiny/base-files/etc/board.d/01_leds | 8 ++++++++ target/linux/ath79/tiny/base-files/etc/board.d/02_network | 10 ++++++++++ .../tiny/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom | 3 +++ 3 files changed, 21 insertions(+) (limited to 'target/linux/ath79/tiny') diff --git a/target/linux/ath79/tiny/base-files/etc/board.d/01_leds b/target/linux/ath79/tiny/base-files/etc/board.d/01_leds index 26926b6f64..f0b4acf066 100755 --- a/target/linux/ath79/tiny/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/tiny/base-files/etc/board.d/01_leds @@ -21,6 +21,14 @@ tplink,tl-wr941-v4) ucidef_set_led_switch "lan3" "LAN3" "green:lan3" "switch0" "0x08" ucidef_set_led_switch "lan4" "LAN4" "green:lan4" "switch0" "0x10" ;; +engenius,enh202-v1) + ucidef_set_led_switch "lan" "LAN" "amber:lan" "switch0" "0x10" + ucidef_set_led_netdev "wan" "WAN" "green:wan" "eth0" + ucidef_set_rssimon "wlan0" "200000" "1" + ucidef_set_led_rssi "rssilow" "RSSILOW" "red:rssilow" "wlan0" "1" "100" + ucidef_set_led_rssi "rssimedium" "RSSIMEDIUM" "amber:rssimedium" "wlan0" "33" "100" + ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "green:rssihigh" "wlan0" "67" "100" + ;; netgear,wnr1000-v2|\ netgear,wnr2000-v3) ucidef_set_led_netdev "wan-amber" "WAN (amber)" "amber:wan" "eth0" diff --git a/target/linux/ath79/tiny/base-files/etc/board.d/02_network b/target/linux/ath79/tiny/base-files/etc/board.d/02_network index cbcdbe9a89..ce95bf7037 100755 --- a/target/linux/ath79/tiny/base-files/etc/board.d/02_network +++ b/target/linux/ath79/tiny/base-files/etc/board.d/02_network @@ -28,6 +28,8 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth1" "1:lan" "2:lan" "3:lan" "4:lan" ;; + engenius,eap350-v1|\ + engenius,ecb350-v1|\ pqi,air-pen|\ tplink,tl-mr10u|\ tplink,tl-mr3020-v1|\ @@ -51,6 +53,11 @@ ath79_setup_interfaces() tplink,tl-wr802n-v2) ucidef_set_interface_lan "eth0" ;; + engenius,enh202-v1) + ucidef_set_interface_wan "eth0" + ucidef_add_switch "switch0" \ + "0@eth1" "4:lan:1" + ;; tplink,tl-mr3220-v1|\ tplink,tl-mr3420-v1|\ tplink,tl-mr3420-v3|\ @@ -99,6 +106,9 @@ ath79_setup_macs() wan_mac=$(mtd_get_mac_ascii "nvram" "wan_mac") label_mac=$wan_mac ;; + engenius,enh202-v1) + label_mac=$(cat /sys/class/ieee80211/phy0/macaddress) + ;; tplink,tl-wr941-v2|\ tplink,tl-wr941n-v7-cn) base_mac=$(mtd_get_mac_binary u-boot 0x1fc00) diff --git a/target/linux/ath79/tiny/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/tiny/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index 6ae2dc5f94..ffbc46afd0 100644 --- a/target/linux/ath79/tiny/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/tiny/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -10,6 +10,9 @@ case "$FIRMWARE" in "ath9k-eeprom-pci-0000:00:00.0.bin") case $board in buffalo,whr-g301n|\ + engenius,eap350-v1|\ + engenius,ecb350-v1|\ + engenius,enh202-v1|\ tplink,tl-wa701nd-v1|\ tplink,tl-wa730re-v1|\ tplink,tl-wa801nd-v1|\ -- cgit v1.2.3