From 9261e7447ea7b8d33b70ff6ea008f2041a88e255 Mon Sep 17 00:00:00 2001 From: Hauke Mehrtens Date: Thu, 1 Nov 2018 18:01:44 +0100 Subject: kernel: Make the patches apply on top of 4.19 This makes the patches which were just copied in the previous commit apply on top of kernel 4.19. The patches in the backports-4.19 folder were checked if they are really in kernel 4.19 based on the title and only removed if they were found in the upstream kernel. The following additional patches form the pending folder went into upstream Linux 4.19: pending-4.19/171-usb-dwc2-Fix-inefficient-copy-of-unaligned-buffers.patch pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch pending-4.19/478-mtd-spi-nor-Add-support-for-XM25QH64A-and-XM25QH128A.patch pending-4.19/479-mtd-spi-nor-add-eon-en25qh32.patch pending-4.19/950-tty-serial-exar-generalize-rs485-setup.patch pending-4.19/340-MIPS-mm-remove-mips_dma_mapping_error.patch Bigger changes were introduced to the m25p80 spi nor driver, as far as I saw it in the new code, it now has the functionality provided in this patch: pending-4.19/450-mtd-m25p80-allow-fallback-from-spi_flash_read-to-reg.patch Part of this patch went upstream independent of OpenWrt: hack-4.19/220-gc_sections.patch This patch was reworked to match the changes done upstream. The MIPS DMA API changed a lot, this patch was rewritten to match the new DMA handling: pending-4.19/341-MIPS-mm-remove-no-op-dma_map_ops-where-possible.patch I did bigger manual changes to the following patches and I am not 100% sure if they are all correct: pending-4.19/0931-w1-gpio-fix-problem-with-platfom-data-in-w1-gpio.patch pending-4.19/411-mtd-partial_eraseblock_write.patch pending-4.19/600-netfilter_conntrack_flush.patch pending-4.19/611-netfilter_match_bypass_default_table.patch pending-4.19/670-ipv6-allow-rejecting-with-source-address-failed-policy.patch hack-4.19/211-host_tools_portability.patch hack-4.19/221-module_exports.patch hack-4.19/321-powerpc_crtsavres_prereq.patch hack-4.19/902-debloat_proc.patch This is based on patchset from Marko Ratkaj Signed-off-by: Hauke Mehrtens --- ...x-wrong-comment-related-to-link-detection.patch | 43 ---------------------- 1 file changed, 43 deletions(-) delete mode 100644 target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch (limited to 'target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch') diff --git a/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch b/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch deleted file mode 100644 index 54858657cb..0000000000 --- a/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch +++ /dev/null @@ -1,43 +0,0 @@ -From patchwork Fri Jul 21 18:36:24 2017 -Content-Type: text/plain; charset="utf-8" -MIME-Version: 1.0 -Content-Transfer-Encoding: 7bit -Subject: [2/5] e1000e: Fix wrong comment related to link detection -From: Benjamin Poirier -X-Patchwork-Id: 9857489 -Message-Id: <20170721183627.13373-2-bpoirier@suse.com> -To: Jeff Kirsher -Cc: Lennart Sorensen , - intel-wired-lan@lists.osuosl.org, netdev@vger.kernel.org, - linux-kernel@vger.kernel.org -Date: Fri, 21 Jul 2017 11:36:24 -0700 - -Reading e1000e_check_for_copper_link() shows that get_link_status is set to -false after link has been detected. Therefore, it stays TRUE until then. - -Signed-off-by: Benjamin Poirier -Tested-by: Aaron Brown ---- - drivers/net/ethernet/intel/e1000e/netdev.c | 4 ++-- - 1 file changed, 2 insertions(+), 2 deletions(-) - ---- a/drivers/net/ethernet/intel/e1000e/netdev.c -+++ b/drivers/net/ethernet/intel/e1000e/netdev.c -@@ -5082,7 +5082,7 @@ static bool e1000e_has_link(struct e1000 - - /* get_link_status is set on LSC (link status) interrupt or - * Rx sequence error interrupt. get_link_status will stay -- * false until the check_for_link establishes link -+ * true until the check_for_link establishes link - * for copper adapters ONLY - */ - switch (hw->phy.media_type) { -@@ -5100,7 +5100,7 @@ static bool e1000e_has_link(struct e1000 - break; - case e1000_media_type_internal_serdes: - ret_val = hw->mac.ops.check_for_link(hw); -- link_active = adapter->hw.mac.serdes_has_link; -+ link_active = hw->mac.serdes_has_link; - break; - default: - case e1000_media_type_unknown: -- cgit v1.2.3