From b3841e7de0be51ddb4e0d17ab0561a12c6db2753 Mon Sep 17 00:00:00 2001 From: Alex Marginean Date: Wed, 8 Jan 2020 12:34:33 +0200 Subject: [PATCH] drivers: net: dsa: felix: Allow PHY to AN 10/100/1000 with 2500 serdes link If the serdes link is set to 2500 using interfce type 2500base-X, lower link speeds over on the line side should still be supported. Rate adaptation is done out of band, in our case using AQR PHYs this is done using flow control. Signed-off-by: Alex Marginean --- drivers/net/dsa/ocelot/felix.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-) --- a/drivers/net/dsa/ocelot/felix.c +++ b/drivers/net/dsa/ocelot/felix.c @@ -218,11 +218,10 @@ static void felix_phylink_validate(struc phylink_set(mask, Autoneg); phylink_set(mask, Pause); phylink_set(mask, Asym_Pause); - if (state->interface != PHY_INTERFACE_MODE_2500BASEX) { - phylink_set(mask, 10baseT_Full); - phylink_set(mask, 100baseT_Full); - phylink_set(mask, 1000baseT_Full); - } + phylink_set(mask, 10baseT_Full); + phylink_set(mask, 100baseT_Full); + phylink_set(mask, 1000baseT_Full); + /* The internal ports that run at 2.5G are overclocked GMII */ if (state->interface == PHY_INTERFACE_MODE_GMII || state->interface == PHY_INTERFACE_MODE_2500BASEX ||