#include "mt7620a.dtsi" #include #include / { compatible = "dovado,tiny-ac", "ralink,mt7620a-soc"; model = "Dovado Tiny AC"; leds { compatible = "gpio-leds"; usb { label = "tiny-ac:green:usb"; gpios = <&gpio0 11 GPIO_ACTIVE_LOW>; trigger-sources = <&ohci_port1>, <&ehci_port1>; linux,default-trigger = "usbport"; }; wifi { label = "tiny-ac:orange:wifi"; gpios = <&gpio3 0 GPIO_ACTIVE_LOW>; }; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; linux,code = ; }; }; gpio_export { compatible = "gpio-export"; #size-cells = <0>; usbpower { gpio-export,name = "usbpower"; gpio-export,output = <1>; gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; }; }; }; &gpio0 { status = "okay"; }; &gpio2 { status = "okay"; }; &gpio3 { status = "okay"; }; &spi0 { status = "okay"; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <10000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@30000 { label = "u-boot-env"; reg = <0x30000 0x10000>; read-only; }; factory: partition@40000 { label = "factory"; reg = <0x40000 0x10000>; read-only; }; partition@50000 { compatible = "denx,uimage"; label = "firmware"; reg = <0x50000 0x7b0000>; }; }; }; }; &ehci { status = "okay"; }; &ohci { status = "okay"; }; ðernet { pinctrl-names = "default"; pinctrl-0 = <&rgmii1_pins &rgmii2_pins &mdio_pins>; mediatek,portmap = "llllw"; port@4 { status = "okay"; phy-mode = "rgmii"; phy-handle = <&phy4>; }; port@5 { status = "okay"; phy-mode = "rgmii"; phy-handle = <&phy5>; }; mdio-bus { status = "okay"; phy4: ethernet-phy@4 { reg = <4>; phy-mode = "rgmii"; }; phy5: ethernet-phy@5 { reg = <5>; phy-mode = "rgmii"; }; }; }; &gsw { mediatek,port4 = "gmac"; }; &pcie { status = "okay"; }; &state_default { gpio { groups = "uartf", "nd_sd", "wled"; function = "gpio"; }; }; &pcie0 { mt76@0,0 { reg = <0x0000 0 0 0 0>; mediatek,mtd-eeprom = <&factory 0x8000>; ieee80211-freq-limit = <5000000 6000000>; }; };