diff options
Diffstat (limited to 'Smol Watch Project/My Project/hal/include/hal_gpio.h')
| -rw-r--r-- | Smol Watch Project/My Project/hal/include/hal_gpio.h | 201 |
1 files changed, 0 insertions, 201 deletions
diff --git a/Smol Watch Project/My Project/hal/include/hal_gpio.h b/Smol Watch Project/My Project/hal/include/hal_gpio.h deleted file mode 100644 index fbfa2d4a..00000000 --- a/Smol Watch Project/My Project/hal/include/hal_gpio.h +++ /dev/null @@ -1,201 +0,0 @@ -/** - * \file - * - * \brief Port - * - * Copyright (c) 2014-2018 Microchip Technology Inc. and its subsidiaries. - * - * \asf_license_start - * - * \page License - * - * Subject to your compliance with these terms, you may use Microchip - * software and any derivatives exclusively with Microchip products. - * It is your responsibility to comply with third party license terms applicable - * to your use of third party software (including open source software) that - * may accompany Microchip software. - * - * THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES, - * WHETHER EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE, - * INCLUDING ANY IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY, - * AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE - * LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL - * LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND WHATSOEVER RELATED TO THE - * SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS BEEN ADVISED OF THE - * POSSIBILITY OR THE DAMAGES ARE FORESEEABLE. TO THE FULLEST EXTENT - * ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN ANY WAY - * RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY, - * THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE. - * - * \asf_license_stop - */ -#ifndef _HAL_GPIO_INCLUDED_ -#define _HAL_GPIO_INCLUDED_ - -#include <hpl_gpio.h> -#include <utils_assert.h> - -#ifdef __cplusplus -extern "C" { -#endif - -/** - * \brief Set gpio pull mode - * - * Set pin pull mode, non existing pull modes throws an fatal assert - * - * \param[in] pin The pin number for device - * \param[in] pull_mode GPIO_PULL_DOWN = Pull pin low with internal resistor - * GPIO_PULL_UP = Pull pin high with internal resistor - * GPIO_PULL_OFF = Disable pin pull mode - */ -static inline void gpio_set_pin_pull_mode(const uint8_t pin, const enum gpio_pull_mode pull_mode) -{ - _gpio_set_pin_pull_mode((enum gpio_port)GPIO_PORT(pin), pin & 0x1F, pull_mode); -} - -/** - * \brief Set pin function - * - * Select which function a pin will be used for - * - * \param[in] pin The pin number for device - * \param[in] function The pin function is given by a 32-bit wide bitfield - * found in the header files for the device - * - */ -static inline void gpio_set_pin_function(const uint32_t pin, uint32_t function) -{ - _gpio_set_pin_function(pin, function); -} - -/** - * \brief Set port data direction - * - * Select if the pin data direction is input, output or disabled. - * If disabled state is not possible, this function throws an assert. - * - * \param[in] port Ports are grouped into groups of maximum 32 pins, - * GPIO_PORTA = group 0, GPIO_PORTB = group 1, etc - * \param[in] mask Bit mask where 1 means apply direction setting to the - * corresponding pin - * \param[in] direction GPIO_DIRECTION_IN = Data direction in - * GPIO_DIRECTION_OUT = Data direction out - * GPIO_DIRECTION_OFF = Disables the pin - * (low power state) - */ -static inline void gpio_set_port_direction(const enum gpio_port port, const uint32_t mask, - const enum gpio_direction direction) -{ - _gpio_set_direction(port, mask, direction); -} - -/** - * \brief Set gpio data direction - * - * Select if the pin data direction is input, output or disabled. - * If disabled state is not possible, this function throws an assert. - * - * \param[in] pin The pin number for device - * \param[in] direction GPIO_DIRECTION_IN = Data direction in - * GPIO_DIRECTION_OUT = Data direction out - * GPIO_DIRECTION_OFF = Disables the pin - * (low power state) - */ -static inline void gpio_set_pin_direction(const uint8_t pin, const enum gpio_direction direction) -{ - _gpio_set_direction((enum gpio_port)GPIO_PORT(pin), 1U << GPIO_PIN(pin), direction); -} - -/** - * \brief Set port level - * - * Sets output level on the pins defined by the bit mask - * - * \param[in] port Ports are grouped into groups of maximum 32 pins, - * GPIO_PORTA = group 0, GPIO_PORTB = group 1, etc - * \param[in] mask Bit mask where 1 means apply port level to the corresponding - * pin - * \param[in] level true = Pin levels set to "high" state - * false = Pin levels set to "low" state - */ -static inline void gpio_set_port_level(const enum gpio_port port, const uint32_t mask, const bool level) -{ - _gpio_set_level(port, mask, level); -} - -/** - * \brief Set gpio level - * - * Sets output level on a pin - * - * \param[in] pin The pin number for device - * \param[in] level true = Pin level set to "high" state - * false = Pin level set to "low" state - */ -static inline void gpio_set_pin_level(const uint8_t pin, const bool level) -{ - _gpio_set_level((enum gpio_port)GPIO_PORT(pin), 1U << GPIO_PIN(pin), level); -} - -/** - * \brief Toggle out level on pins - * - * Toggle the pin levels on pins defined by bit mask - * - * \param[in] port Ports are grouped into groups of maximum 32 pins, - * GPIO_PORTA = group 0, GPIO_PORTB = group 1, etc - * \param[in] mask Bit mask where 1 means toggle pin level to the corresponding - * pin - */ -static inline void gpio_toggle_port_level(const enum gpio_port port, const uint32_t mask) -{ - _gpio_toggle_level(port, mask); -} - -/** - * \brief Toggle output level on pin - * - * Toggle the pin levels on pins defined by bit mask - * - * \param[in] pin The pin number for device - */ -static inline void gpio_toggle_pin_level(const uint8_t pin) -{ - _gpio_toggle_level((enum gpio_port)GPIO_PORT(pin), 1U << GPIO_PIN(pin)); -} - -/** - * \brief Get input level on pins - * - * Read the input level on pins connected to a port - * - * \param[in] port Ports are grouped into groups of maximum 32 pins, - * GPIO_PORTA = group 0, GPIO_PORTB = group 1, etc - */ -static inline uint32_t gpio_get_port_level(const enum gpio_port port) -{ - return _gpio_get_level(port); -} - -/** - * \brief Get level on pin - * - * Reads the level on pins connected to a port - * - * \param[in] pin The pin number for device - */ -static inline bool gpio_get_pin_level(const uint8_t pin) -{ - return (bool)(_gpio_get_level((enum gpio_port)GPIO_PORT(pin)) & (0x01U << GPIO_PIN(pin))); -} -/** - * \brief Get current driver version - */ -uint32_t gpio_get_version(void); - -#ifdef __cplusplus -} -#endif - -#endif |