Use default NVM base address in the AVRISP programmer project in case the host programmer software doesn't set it correctly.

2 files changed, 5 insertions, 4 deletions

diff --git a/Projects/AVRISP/Lib/PDIProtocol.c b/Projects/AVRISP/Lib/PDIProtocol.c
index 1b3fc53c4..43370c730 100644
--- a/Projects/AVRISP/Lib/PDIProtocol.c
+++ b/Projects/AVRISP/Lib/PDIProtocol.c
@@ -38,7 +38,7 @@
 

 #if defined(ENABLE_PDI_PROTOCOL) || defined(__DOXYGEN__)

 /** Base absolute address for the target's NVM controller */

-uint32_t XPROG_Param_NVMBase;

+uint32_t XPROG_Param_NVMBase = 0x010001C0;

 

 /** Size in bytes of the target's EEPROM page */

 uint32_t XPROG_Param_EEPageSize;

diff --git a/Projects/AVRISP/Lib/PDITarget.c b/Projects/AVRISP/Lib/PDITarget.c
index 1bbb4d577..a8fe21e9b 100644
--- a/Projects/AVRISP/Lib/PDITarget.c
+++ b/Projects/AVRISP/Lib/PDITarget.c
@@ -39,14 +39,15 @@
 #if defined(ENABLE_PDI_PROTOCOL) || defined(__DOXYGEN__)

 

 /** Flag to indicate if the USART is currently in Tx or Rx mode. */

-volatile bool     IsSending;

+volatile bool               IsSending;

 

 #if !defined(PDI_VIA_HARDWARE_USART)

 /** Software USART raw frame bits for transmission/reception. */

-volatile uint16_t SoftUSART_Data;

+volatile uint16_t           SoftUSART_Data;

 

 /** Bits remaining to be sent or received via the software USART - set as a GPIOR for speed. */

-#define SoftUSART_BitCount   GPIOR2

+#define SoftUSART_BitCount  GPIOR2

+

 

 /** ISR to manage the software USART when bit-banged USART mode is selected. */

 ISR(TIMER1_COMPA_vect, ISR_BLOCK)