ipq806x: update target to v3.18

Patches in the ipq806x/patches folder were out of tree in v3.14. The
newest patch at the time was from June, so we can safely assume that
either the patches have been merged, or they have been rejected for
a good reason. If patches are seen missing, we'll cherry-pick them
on a per-needed basis.

This new kernel have been tested on AP148, which seems to works fine.

Signed-off-by: Mathieu Olivari <mathieu@codeaurora.org>

git-svn-id: svn://svn.openwrt.org/openwrt/trunk@44386 3c298f89-4303-0410-b956-a3cf2f4a3e73

1 files changed, 0 insertions, 40 deletions

diff --git a/target/linux/ipq806x/patches/0145-phy-qcom-Add-device-tree-bindings-information.patch b/target/linux/ipq806x/patches/0145-phy-qcom-Add-device-tree-bindings-information.patch
deleted file mode 100644
index bd5e5d4fb3..0000000000
--- a/target/linux/ipq806x/patches/0145-phy-qcom-Add-device-tree-bindings-information.patch
+++ /dev/null
@@ -1,40 +0,0 @@
-From 37258bc8fe832e4c681593a864686f627f6d3455 Mon Sep 17 00:00:00 2001
-From: Kumar Gala <galak@codeaurora.org>
-Date: Tue, 10 Jun 2014 13:09:01 -0500
-Subject: [PATCH 145/182] phy: qcom: Add device tree bindings information
-
-Add binding spec for Qualcomm SoC PHYs, starting with the SATA PHY on
-the IPQ806x family of SoCs.
-
-Signed-off-by: Kumar Gala <galak@codeaurora.org>
----
- Documentation/devicetree/bindings/phy/qcom-phy.txt |   23 ++++++++++++++++++++
- 1 file changed, 23 insertions(+)
- create mode 100644 Documentation/devicetree/bindings/phy/qcom-phy.txt
-
---- /dev/null
-+++ b/Documentation/devicetree/bindings/phy/qcom-phy.txt
-@@ -0,0 +1,23 @@
-+Qualcomm IPQ806x SATA PHY Controller
-+------------------------------------
-+
-+SATA PHY nodes are defined to describe on-chip SATA Physical layer controllers.
-+Each SATA PHY controller should have its own node.
-+
-+Required properties:
-+- compatible: compatible list, contains "qcom,ipq806x-sata-phy"
-+- reg: offset and length of the SATA PHY register set;
-+- #phy-cells: must be zero
-+- clocks: must be exactly one entry
-+- clock-names: must be "cfg"
-+
-+Example:
-+	sata_phy: sata-phy@1b400000 {
-+		compatible = "qcom,ipq806x-sata-phy";
-+		reg = <0x1b400000 0x200>;
-+
-+		clocks = <&gcc SATA_PHY_CFG_CLK>;
-+		clock-names = "cfg";
-+
-+		#phy-cells = <0>;
-+	};