diff options
Diffstat (limited to 'shared/opensource/include/bcm963xx/bcm_hwdefs.h')
| -rwxr-xr-x | shared/opensource/include/bcm963xx/bcm_hwdefs.h | 193 |
1 files changed, 193 insertions, 0 deletions
diff --git a/shared/opensource/include/bcm963xx/bcm_hwdefs.h b/shared/opensource/include/bcm963xx/bcm_hwdefs.h new file mode 100755 index 0000000..07ecc29 --- /dev/null +++ b/shared/opensource/include/bcm963xx/bcm_hwdefs.h @@ -0,0 +1,193 @@ +/* + Copyright 2000-2010 Broadcom Corporation + + Unless you and Broadcom execute a separate written software license + agreement governing use of this software, this software is licensed + to you under the terms of the GNU General Public License version 2 + (the “GPL?, available at http://www.broadcom.com/licenses/GPLv2.php, + with the following added to such license: + + As a special exception, the copyright holders of this software give + you permission to link this software with independent modules, and to + copy and distribute the resulting executable under terms of your + choice, provided that you also meet, for each linked independent + module, the terms and conditions of the license of that module. + An independent module is a module which is not derived from this + software. The special exception does not apply to any modifications + of the software. + + Notwithstanding the above, under no circumstances may you combine this + software in any way with any other Broadcom software provided under a + license other than the GPL, without Broadcom's express prior written + consent. +*/ + +/***********************************************************************/ +/* */ +/* MODULE: bcm_hwdefs.h */ +/* PURPOSE: Define all base device addresses and HW specific macros. */ +/* */ +/***********************************************************************/ +#ifndef _BCM_HWDEFS_H +#define _BCM_HWDEFS_H + +#ifdef __cplusplus +extern "C" { +#endif + +#define DYING_GASP_API + +/*****************************************************************************/ +/* Physical Memory Map */ +/*****************************************************************************/ + +#define PHYS_DRAM_BASE 0x00000000 /* Dynamic RAM Base */ +#if defined(CONFIG_BRCM_IKOS) +#define PHYS_FLASH_BASE 0x18000000 /* Flash Memory */ +#else +#define PHYS_FLASH_BASE 0x1FC00000 /* Flash Memory */ +#endif + +/*****************************************************************************/ +/* Note that the addresses above are physical addresses and that programs */ +/* have to use converted addresses defined below: */ +/*****************************************************************************/ +#define DRAM_BASE (0x80000000 | PHYS_DRAM_BASE) /* cached DRAM */ +#define DRAM_BASE_NOCACHE (0xA0000000 | PHYS_DRAM_BASE) /* uncached DRAM */ + +/* Binary images are always built for a standard MIPS boot address */ +#define IMAGE_BASE (0xA0000000 | PHYS_FLASH_BASE) + +/* Some chips don't support alternative boot vector */ +#if defined(CONFIG_BRCM_IKOS) +#define FLASH_BASE (0xA0000000 | PHYS_FLASH_BASE) /* uncached Flash */ +#define BOOT_OFFSET 0 +#else +#if defined(_BCM96328_) || defined(CONFIG_BCM96328) || defined(_BCM96362_) || defined(CONFIG_BCM96362) +#define FLASH_BASE 0xB8000000 +#else +#define FLASH_BASE (0xA0000000 | (MPI->cs[0].base & 0xFFFFFF00)) +#endif +#define BOOT_OFFSET (FLASH_BASE - IMAGE_BASE) +#endif + +/*****************************************************************************/ +/* Select the PLL value to get the desired CPU clock frequency. */ +/*****************************************************************************/ +#define FPERIPH 50000000 + +/*****************************************************************************/ +/* Board memory type offset */ +/*****************************************************************************/ +#define ONEK 1024 +#define FLASH_LENGTH_BOOT_ROM (64*ONEK) + +#define PROJECT_ID_LEN 7 /* Foxconn added by zacker, 02/29/2008, strlen("U12H094") */ +#ifdef _CFE_ +#define FLASH_SIZE 32 * 1024 * 1024 +#endif +#define BOARD_DATA_ADDR (FLASH_BASE + FLASH_SIZE - 0x20000) +#define BOARD_FOXNVRAM_ADDR (FLASH_BASE + FLASH_SIZE - 0x10000) +#define FOX_BOARD_ID_MAX_LEN 64 +#define BOARD_ID "U12L161" +/*****************************************************************************/ +/* NVRAM Offset and definition */ +/*****************************************************************************/ +#define NVRAM_SECTOR 0 +#define NVRAM_DATA_OFFSET 0x0580 +#define NVRAM_DATA_ID 0x0f1e2d3c // This is only for backwards compatability + +#define NVRAM_LENGTH ONEK // 1k nvram +#define NVRAM_VERSION_NUMBER 6 +#define NVRAM_FULL_LEN_VERSION_NUMBER 5 /* version in which the checksum was + placed at the end of the NVRAM + structure */ + +#define NVRAM_BOOTLINE_LEN 256 +#define NVRAM_BOARD_ID_STRING_LEN 16 +#define NVRAM_MAC_ADDRESS_LEN 6 + +#define NVRAM_GPON_SERIAL_NUMBER_LEN 13 +#define NVRAM_GPON_PASSWORD_LEN 11 + +#define NVRAM_WLAN_PARAMS_LEN 256 +#define NVRAM_WPS_DEVICE_PIN_LEN 8 + +#define THREAD_NUM_ADDRESS_OFFSET (NVRAM_DATA_OFFSET + 4 + NVRAM_BOOTLINE_LEN + NVRAM_BOARD_ID_STRING_LEN) +#define THREAD_NUM_ADDRESS (0x80000000 + THREAD_NUM_ADDRESS_OFFSET) + +#define DEFAULT_BOOTLINE "e=192.168.1.1:ffffff00 h=192.168.1.100 g= r=f f=vmlinux i=bcm963xx_fs_kernel d=1 p=0 " +#define DEFAULT_BOARD_IP "192.168.1.1" +#define DEFAULT_MAC_NUM 10 +#define DEFAULT_BOARD_MAC "00:10:18:00:00:00" +#define DEFAULT_TP_NUM 0 +#define DEFAULT_PSI_SIZE 24 +#define DEFAULT_GPON_SN "BRCM12345678" +#define DEFAULT_GPON_PW " " + +#define DEFAULT_WPS_DEVICE_PIN "12345670" + +#define DEFAULT_VOICE_BOARD_ID "NONE" + +#define NVRAM_MAC_COUNT_MAX 32 +#define NVRAM_MAX_PSI_SIZE 64 +#define NVRAM_MAX_SYSLOG_SIZE 256 + +#define NP_BOOT 0 +#define NP_ROOTFS_1 1 +#define NP_ROOTFS_2 2 +#define NP_DATA 3 +#define NP_BBT 4 +#define NP_TOTAL 5 + +#define NAND_DATA_SIZE_KB 1024 +#define NAND_BBT_THRESHOLD_KB (512 * 1024) +#define NAND_BBT_SMALL_SIZE_KB 1024 +#define NAND_BBT_BIG_SIZE_KB 4096 + +#define NAND_CFE_RAM_NAME "cferam.000" + +#ifndef _LANGUAGE_ASSEMBLY +typedef struct +{ + unsigned long ulVersion; + char szBootline[NVRAM_BOOTLINE_LEN]; + char szBoardId[NVRAM_BOARD_ID_STRING_LEN]; + unsigned long ulMainTpNum; + unsigned long ulPsiSize; + unsigned long ulNumMacAddrs; + unsigned char ucaBaseMacAddr[NVRAM_MAC_ADDRESS_LEN]; + char pad; + char backupPsi; /**< if 0x01, allocate space for a backup PSI */ + unsigned long ulCheckSumV4; + char gponSerialNumber[NVRAM_GPON_SERIAL_NUMBER_LEN]; + char gponPassword[NVRAM_GPON_PASSWORD_LEN]; + char wpsDevicePin[NVRAM_WPS_DEVICE_PIN_LEN]; + char wlanParams[NVRAM_WLAN_PARAMS_LEN]; + unsigned long ulSyslogSize; /**< number of KB to allocate for persistent syslog */ + unsigned long ulNandPartOfsKb[NP_TOTAL]; + unsigned long ulNandPartSizeKb[NP_TOTAL]; + char szVoiceBoardId[NVRAM_BOARD_ID_STRING_LEN]; + unsigned long afeId[2]; + char szFirmwareUpgradeBoardId[32]; /* foxconn added Bob, 07/12/2010, for TFTP firmware upgrade */ + char chUnused[332]; /* reduce array size from 364 to 332, total size of NVRAM_DATA is unchanged, Bob, 07/12/2010 */ + unsigned long ulCheckSum; +} NVRAM_DATA, *PNVRAM_DATA; +#endif + +#define BOOT_LATEST_IMAGE '0' +#define BOOT_PREVIOUS_IMAGE '1' + +/*****************************************************************************/ +/* Misc Offsets */ +/*****************************************************************************/ +#define CFE_VERSION_OFFSET 0x0570 +#define CFE_VERSION_MARK_SIZE 5 +#define CFE_VERSION_SIZE 5 + +#ifdef __cplusplus +} +#endif + +#endif /* _BCM_HWDEFS_H */ + |