1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
|
--- a/arch/mips/ath25/Kconfig
+++ b/arch/mips/ath25/Kconfig
@@ -1,6 +1,7 @@
config SOC_AR5312
bool "Atheros AR5312/AR2312+ SoC support"
depends on ATH25
+ select GPIO_AR5312
default y
config SOC_AR2315
--- a/arch/mips/ath25/ar5312.c
+++ b/arch/mips/ath25/ar5312.c
@@ -22,6 +22,7 @@
#include <linux/platform_device.h>
#include <linux/mtd/physmap.h>
#include <linux/reboot.h>
+#include <linux/gpio.h>
#include <asm/bootinfo.h>
#include <asm/reboot.h>
#include <asm/time.h>
@@ -180,6 +181,22 @@ static struct platform_device ar5312_phy
.num_resources = 1,
};
+static struct resource ar5312_gpio_res[] = {
+ {
+ .name = "ar5312-gpio",
+ .flags = IORESOURCE_MEM,
+ .start = AR5312_GPIO_BASE,
+ .end = AR5312_GPIO_BASE + AR5312_GPIO_SIZE - 1,
+ },
+};
+
+static struct platform_device ar5312_gpio = {
+ .name = "ar5312-gpio",
+ .id = -1,
+ .resource = ar5312_gpio_res,
+ .num_resources = ARRAY_SIZE(ar5312_gpio_res),
+};
+
static void __init ar5312_flash_init(void)
{
void __iomem *flashctl_base;
@@ -247,6 +264,8 @@ void __init ar5312_init_devices(void)
platform_device_register(&ar5312_physmap_flash);
+ platform_device_register(&ar5312_gpio);
+
switch (ath25_soc) {
case ATH25_SOC_AR5312:
if (!ath25_board.radio)
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -142,6 +142,13 @@ config GPIO_BRCMSTB
help
Say yes here to enable GPIO support for Broadcom STB (BCM7XXX) SoCs.
+config GPIO_AR5312
+ bool "AR5312 SoC GPIO support"
+ default y if SOC_AR5312
+ depends on SOC_AR5312
+ help
+ Say yes here to enable GPIO support for Atheros AR5312/AR2312+ SoCs.
+
config GPIO_CLPS711X
tristate "CLPS711X GPIO support"
depends on ARCH_CLPS711X || COMPILE_TEST
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -21,6 +21,7 @@ obj-$(CONFIG_GPIO_ADP5588) += gpio-adp55
obj-$(CONFIG_GPIO_ALTERA) += gpio-altera.o
obj-$(CONFIG_GPIO_AMD8111) += gpio-amd8111.o
obj-$(CONFIG_GPIO_AMDPT) += gpio-amdpt.o
+obj-$(CONFIG_GPIO_AR5312) += gpio-ar5312.o
obj-$(CONFIG_GPIO_ARIZONA) += gpio-arizona.o
obj-$(CONFIG_ATH79) += gpio-ath79.o
obj-$(CONFIG_GPIO_BCM_KONA) += gpio-bcm-kona.o
--- /dev/null
+++ b/drivers/gpio/gpio-ar5312.c
@@ -0,0 +1,121 @@
+/*
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License. See the file "COPYING" in the main directory of this archive
+ * for more details.
+ *
+ * Copyright (C) 2003 Atheros Communications, Inc., All Rights Reserved.
+ * Copyright (C) 2006 FON Technology, SL.
+ * Copyright (C) 2006 Imre Kaloz <kaloz@openwrt.org>
+ * Copyright (C) 2006-2009 Felix Fietkau <nbd@nbd.name>
+ * Copyright (C) 2012 Alexandros C. Couloumbis <alex@ozo.com>
+ */
+
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/platform_device.h>
+#include <linux/gpio.h>
+
+#define DRIVER_NAME "ar5312-gpio"
+
+#define AR5312_GPIO_DO 0x00 /* output register */
+#define AR5312_GPIO_DI 0x04 /* intput register */
+#define AR5312_GPIO_CR 0x08 /* control register */
+
+#define AR5312_GPIO_CR_M(x) (1 << (x)) /* mask for i/o */
+#define AR5312_GPIO_CR_O(x) (0 << (x)) /* mask for output */
+#define AR5312_GPIO_CR_I(x) (1 << (x)) /* mask for input */
+#define AR5312_GPIO_CR_INT(x) (1 << ((x)+8)) /* mask for interrupt */
+#define AR5312_GPIO_CR_UART(x) (1 << ((x)+16)) /* uart multiplex */
+
+#define AR5312_GPIO_NUM 8
+
+static void __iomem *ar5312_mem;
+
+static inline u32 ar5312_gpio_reg_read(unsigned reg)
+{
+ return __raw_readl(ar5312_mem + reg);
+}
+
+static inline void ar5312_gpio_reg_write(unsigned reg, u32 val)
+{
+ __raw_writel(val, ar5312_mem + reg);
+}
+
+static inline void ar5312_gpio_reg_mask(unsigned reg, u32 mask, u32 val)
+{
+ ar5312_gpio_reg_write(reg, (ar5312_gpio_reg_read(reg) & ~mask) | val);
+}
+
+static int ar5312_gpio_get_val(struct gpio_chip *chip, unsigned gpio)
+{
+ return (ar5312_gpio_reg_read(AR5312_GPIO_DI) >> gpio) & 1;
+}
+
+static void ar5312_gpio_set_val(struct gpio_chip *chip, unsigned gpio, int val)
+{
+ u32 reg = ar5312_gpio_reg_read(AR5312_GPIO_DO);
+
+ reg = val ? reg | (1 << gpio) : reg & ~(1 << gpio);
+ ar5312_gpio_reg_write(AR5312_GPIO_DO, reg);
+}
+
+static int ar5312_gpio_dir_in(struct gpio_chip *chip, unsigned gpio)
+{
+ ar5312_gpio_reg_mask(AR5312_GPIO_CR, 0, 1 << gpio);
+ return 0;
+}
+
+static int ar5312_gpio_dir_out(struct gpio_chip *chip, unsigned gpio, int val)
+{
+ ar5312_gpio_reg_mask(AR5312_GPIO_CR, 1 << gpio, 0);
+ ar5312_gpio_set_val(chip, gpio, val);
+ return 0;
+}
+
+static struct gpio_chip ar5312_gpio_chip = {
+ .label = DRIVER_NAME,
+ .direction_input = ar5312_gpio_dir_in,
+ .direction_output = ar5312_gpio_dir_out,
+ .set = ar5312_gpio_set_val,
+ .get = ar5312_gpio_get_val,
+ .base = 0,
+ .ngpio = AR5312_GPIO_NUM,
+};
+
+static int ar5312_gpio_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct resource *res;
+ int ret;
+
+ if (ar5312_mem)
+ return -EBUSY;
+
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ ar5312_mem = devm_ioremap_resource(dev, res);
+ if (IS_ERR(ar5312_mem))
+ return PTR_ERR(ar5312_mem);
+
+ ar5312_gpio_chip.dev = dev;
+ ret = gpiochip_add(&ar5312_gpio_chip);
+ if (ret) {
+ dev_err(dev, "failed to add gpiochip\n");
+ return ret;
+ }
+
+ return 0;
+}
+
+static struct platform_driver ar5312_gpio_driver = {
+ .probe = ar5312_gpio_probe,
+ .driver = {
+ .name = DRIVER_NAME,
+ .owner = THIS_MODULE,
+ }
+};
+
+static int __init ar5312_gpio_init(void)
+{
+ return platform_driver_register(&ar5312_gpio_driver);
+}
+subsys_initcall(ar5312_gpio_init);
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -117,6 +117,7 @@ config ATH25
select SYS_SUPPORTS_BIG_ENDIAN
select SYS_SUPPORTS_32BIT_KERNEL
select SYS_HAS_EARLY_PRINTK
+ select ARCH_REQUIRE_GPIOLIB
help
Support for Atheros AR231x and Atheros AR531x based boards
|
