1 files changed, 101 insertions, 0 deletions
diff --git a/boards/base/Olimex-STM32-LCD/board_ILI9320.h b/boards/base/Olimex-STM32-LCD/board_ILI9320.h
new file mode 100644
index 00000000..fb8c4590
--- /dev/null
+++ b/boards/base/Olimex-STM32-LCD/board_ILI9320.h
@@ -0,0 +1,101 @@
+/*
+ * This file is subject to the terms of the GFX License. If a copy of
+ * the license was not distributed with this file, you can obtain one at:
+ *
+ *              http://ugfx.org/license.html
+ */
+
+#ifndef GDISP_LLD_BOARD_H
+#define GDISP_LLD_BOARD_H
+
+// For a multiple display configuration we would put all this in a structure and then
+//	set g->board to that structure.
+#define GDISP_REG              (*((volatile uint16_t *) 0x60000000)) /* RS = 0 */
+#define GDISP_RAM              (*((volatile uint16_t *) 0x60100000)) /* RS = 1 */
+
+static inline void init_board(GDisplay *g) {
+
+	// As we are not using multiple displays we set g->board to NULL as we don't use it.
+	g->board = 0;
+
+	switch(g->controllerdisplay) {
+	case 0:											// Set up for Display 0
+		/* FSMC setup for F1 */
+		rccEnableAHB(RCC_AHBENR_FSMCEN, 0);
+
+		/* set pin modes */
+		IOBus busD = {GPIOD, PAL_WHOLE_PORT, 0};
+		IOBus busE = {GPIOE, PAL_WHOLE_PORT, 0};
+		palSetBusMode(&busD, PAL_MODE_STM32_ALTERNATE_PUSHPULL);
+		palSetBusMode(&busE, PAL_MODE_STM32_ALTERNATE_PUSHPULL);
+		palSetPadMode(GPIOE, GPIOE_TFT_RST, PAL_MODE_OUTPUT_PUSHPULL);
+		palSetPadMode(GPIOD, GPIOD_TFT_LIGHT, PAL_MODE_OUTPUT_PUSHPULL);
+
+		/* FSMC timing */
+		FSMC_Bank1->BTCR[0+1] = (6) | (10 << 8) | (10 << 16);
+
+		/* Bank1 NOR/SRAM control register configuration
+		 * This is actually not needed as already set by default after reset */
+		FSMC_Bank1->BTCR[0] = FSMC_BCR1_MWID_0 | FSMC_BCR1_WREN | FSMC_BCR1_MBKEN;
+		break;
+	}
+}
+
+static inline void post_init_board(GDisplay *g) {
+	(void) g;
+}
+
+static inline void setpin_reset(GDisplay *g, bool_t state) {
+	(void) g;
+
+	if(state)
+		palClearPad(GPIOE, GPIOE_TFT_RST);
+	else
+		palSetPad(GPIOE, GPIOE_TFT_RST);
+}
+
+static inline void set_backlight(GDisplay *g, uint8_t percent) {
+	(void) g;
+
+	if(percent)
+		palClearPad(GPIOD, GPIOD_TFT_LIGHT);
+	else
+		palSetPad(GPIOD, GPIOD_TFT_LIGHT);
+}
+
+static inline void acquire_bus(GDisplay *g) {
+	(void) g;
+}
+
+static inline void release_bus(GDisplay *g) {
+	(void) g;
+}
+
+static inline void write_index(GDisplay *g, uint16_t index) {
+	(void) g;
+
+	GDISP_REG = index;
+}
+
+static inline void write_data(GDisplay *g, uint16_t data) {
+	(void) g;
+
+	GDISP_RAM = data;
+}
+
+static inline void setreadmode(GDisplay *g) {
+	(void) g;
+}
+
+static inline void setwritemode(GDisplay *g) {
+	(void) g;
+}
+
+static inline uint16_t read_data(GDisplay *g) {
+	(void) g;
+
+	return GDISP_RAM;
+}
+
+#endif /* GDISP_LLD_BOARD_H */
+