aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/ath79
diff options
context:
space:
mode:
authorSven Eckelmann <sven@narfation.org>2020-11-23 13:41:34 +0100
committerAdrian Schmutzler <freifunk@adrianschmutzler.de>2021-01-19 21:41:26 +0100
commitae7680dc4bf914d640dba32c8f1c36631768a56a (patch)
tree6a4a2471d34ed625061fca2f6f5234748c6dcba6 /target/linux/ath79
parent847cda16eba23d4436a01b7313a21426b9c606fb (diff)
downloadupstream-ae7680dc4bf914d640dba32c8f1c36631768a56a.tar.gz
upstream-ae7680dc4bf914d640dba32c8f1c36631768a56a.tar.bz2
upstream-ae7680dc4bf914d640dba32c8f1c36631768a56a.zip
ath79: Add support for OpenMesh MR1750 v1
Device specifications: ====================== * Qualcomm/Atheros QCA9558 ver 1 rev 0 * 720/600/240 MHz (CPU/DDR/AHB) * 128 MB of RAM * 16 MB of SPI NOR flash - 2x 7 MB available; but one of the 7 MB regions is the recovery image * 3T3R 2.4 GHz Wi-Fi (11n) * 3T3R 5 GHz Wi-Fi (11ac) * 6x GPIO-LEDs (2x wifi, 2x status, 1x lan, 1x power) * 1x GPIO-button (reset) * external h/w watchdog (enabled by default)) * TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX) * 1x ethernet - AR8035 ethernet PHY (RGMII) - 10/100/1000 Mbps Ethernet - 802.3af POE - used as LAN interface * 12-24V 1A DC * internal antennas Flashing instructions: ====================== Various methods can be used to install the actual image on the flash. Two easy ones are: ap51-flash ---------- The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be used to transfer the image to the u-boot when the device boots up. initramfs from TFTP ------------------- The serial console must be used to access the u-boot shell during bootup. It can then be used to first boot up the initramfs image from a TFTP server (here with the IP 192.168.1.21): setenv serverip 192.168.1.21 setenv ipaddr 192.168.1.1 tftpboot 0c00000 <filename-of-initramfs-kernel>.bin && bootm $fileaddr The actual sysupgrade image can then be transferred (on the LAN port) to the device via scp <filename-of-squashfs-sysupgrade>.bin root@192.168.1.1:/tmp/ On the device, the sysupgrade must then be started using sysupgrade -n /tmp/<filename-of-squashfs-sysupgrade>.bin Signed-off-by: Sven Eckelmann <sven@narfation.org> [rebase, apply shared DTSI/device node, add LED migration] Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Diffstat (limited to 'target/linux/ath79')
-rw-r--r--target/linux/ath79/dts/qca9558_openmesh_mr1750-v1.dts16
-rwxr-xr-xtarget/linux/ath79/generic/base-files/etc/board.d/01_leds3
-rwxr-xr-xtarget/linux/ath79/generic/base-files/etc/board.d/02_network1
-rw-r--r--target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata4
-rw-r--r--target/linux/ath79/generic/base-files/etc/uci-defaults/04_led_migration3
-rw-r--r--target/linux/ath79/generic/base-files/lib/upgrade/platform.sh1
-rw-r--r--target/linux/ath79/image/generic.mk11
7 files changed, 37 insertions, 2 deletions
diff --git a/target/linux/ath79/dts/qca9558_openmesh_mr1750-v1.dts b/target/linux/ath79/dts/qca9558_openmesh_mr1750-v1.dts
new file mode 100644
index 0000000000..11eb6dfb55
--- /dev/null
+++ b/target/linux/ath79/dts/qca9558_openmesh_mr1750-v1.dts
@@ -0,0 +1,16 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca9558_openmesh_mr.dtsi"
+
+/ {
+ compatible = "openmesh,mr1750-v1", "qca,qca9558";
+ model = "OpenMesh MR1750 v1";
+};
+
+&led_wifi2g {
+ linux,default-trigger = "phy1tpt";
+};
+
+&led_wifi5g {
+ linux,default-trigger = "phy0tpt";
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
index 8fba9bc0e7..2cdad7dd77 100755
--- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
@@ -159,7 +159,8 @@ comfast,cf-wr752ac-v1|\
engenius,eap300-v2|\
enterasys,ws-ap3705i|\
openmesh,mr900-v1|\
-openmesh,mr900-v2)
+openmesh,mr900-v2|\
+openmesh,mr1750-v1)
ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0"
;;
compex,wpj344-16m|\
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index 76bbd92c21..ef6b70c902 100755
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -50,6 +50,7 @@ ath79_setup_interfaces()
openmesh,mr600-v2|\
openmesh,mr900-v1|\
openmesh,mr900-v2|\
+ openmesh,mr1750-v1|\
pcs,cap324|\
pisen,ts-d084|\
pisen,wmb001n|\
diff --git a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 99d2353ac1..d1a4767648 100644
--- a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -96,6 +96,10 @@ case "$FIRMWARE" in
caldata_extract "art" 0x5000 0x844
ath10k_patch_mac $(mtd_get_mac_binary art 0xc)
;;
+ openmesh,mr1750-v1)
+ caldata_extract "ART" 0x5000 0x844
+ ath10k_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) +16)
+ ;;
openmesh,om5p-ac-v2)
caldata_extract "art" 0x5000 0x844
ath10k_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) +16)
diff --git a/target/linux/ath79/generic/base-files/etc/uci-defaults/04_led_migration b/target/linux/ath79/generic/base-files/etc/uci-defaults/04_led_migration
index 453bf3b911..1d8909f688 100644
--- a/target/linux/ath79/generic/base-files/etc/uci-defaults/04_led_migration
+++ b/target/linux/ath79/generic/base-files/etc/uci-defaults/04_led_migration
@@ -24,7 +24,8 @@ openmesh,mr600-v2)
migrate_leds ":wlan24=:wifi2g" ":wlan58=:wifi5g"
;;
openmesh,mr900-v1|\
-openmesh,mr900-v2)
+openmesh,mr900-v2|\
+openmesh,mr1750-v1)
migrate_leds ":wlan24=:wifi2g" ":wlan58=:wifi5g" ":wan=:lan"
;;
pcs,cap324)
diff --git a/target/linux/ath79/generic/base-files/lib/upgrade/platform.sh b/target/linux/ath79/generic/base-files/lib/upgrade/platform.sh
index 76512758b6..01a9f61943 100644
--- a/target/linux/ath79/generic/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ath79/generic/base-files/lib/upgrade/platform.sh
@@ -54,6 +54,7 @@ platform_do_upgrade() {
openmesh,mr600-v2|\
openmesh,mr900-v1|\
openmesh,mr900-v2|\
+ openmesh,mr1750-v1|\
openmesh,om2p-v2|\
openmesh,om2p-v4|\
openmesh,om2p-hs-v1|\
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index 3d569c9532..92e9458b37 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -1590,6 +1590,17 @@ define Device/openmesh_mr900-v2
endef
TARGET_DEVICES += openmesh_mr900-v2
+define Device/openmesh_mr1750-v1
+ $(Device/openmesh_common_64k)
+ SOC := qca9558
+ DEVICE_MODEL := MR1750
+ DEVICE_VARIANT := v1
+ DEVICE_PACKAGES += kmod-ath10k-ct ath10k-firmware-qca988x-ct
+ OPENMESH_CE_TYPE := MR1750
+ SUPPORTED_DEVICES += mr1750
+endef
+TARGET_DEVICES += openmesh_mr1750-v1
+
define Device/openmesh_om2p-v2
$(Device/openmesh_common_256k)
SOC := ar9330