kernel: Make the patches apply on top of 4.19

This makes the patches which were just copied in the previous commit
apply on top of kernel 4.19.

The patches in the backports-4.19 folder were checked if they are really
in kernel 4.19 based on the title and only removed if they were found in
the upstream kernel.

The following additional patches form the pending folder went into
upstream Linux 4.19:
pending-4.19/171-usb-dwc2-Fix-inefficient-copy-of-unaligned-buffers.patch
pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch
pending-4.19/478-mtd-spi-nor-Add-support-for-XM25QH64A-and-XM25QH128A.patch
pending-4.19/479-mtd-spi-nor-add-eon-en25qh32.patch
pending-4.19/950-tty-serial-exar-generalize-rs485-setup.patch
pending-4.19/340-MIPS-mm-remove-mips_dma_mapping_error.patch

Bigger changes were introduced to the m25p80 spi nor driver, as far as I
saw it in the new code, it now has the functionality provided in this
patch:
pending-4.19/450-mtd-m25p80-allow-fallback-from-spi_flash_read-to-reg.patch

Part of this patch went upstream independent of OpenWrt:
hack-4.19/220-gc_sections.patch
This patch was reworked to match the changes done upstream.

The MIPS DMA API changed a lot, this patch was rewritten to match the
new DMA handling:
pending-4.19/341-MIPS-mm-remove-no-op-dma_map_ops-where-possible.patch

I did bigger manual changes to the following patches and I am not 100% sure if they are all correct:
pending-4.19/0931-w1-gpio-fix-problem-with-platfom-data-in-w1-gpio.patch
pending-4.19/411-mtd-partial_eraseblock_write.patch
pending-4.19/600-netfilter_conntrack_flush.patch
pending-4.19/611-netfilter_match_bypass_default_table.patch
pending-4.19/670-ipv6-allow-rejecting-with-source-address-failed-policy.patch
hack-4.19/211-host_tools_portability.patch
hack-4.19/221-module_exports.patch
hack-4.19/321-powerpc_crtsavres_prereq.patch
hack-4.19/902-debloat_proc.patch

This is based on patchset from Marko Ratkaj <marko.ratkaj@sartura.hr>

Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>

1 files changed, 0 insertions, 43 deletions

diff --git a/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch b/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch
deleted file mode 100644
index 54858657cb..0000000000
--- a/target/linux/generic/pending-4.19/190-2-5-e1000e-Fix-wrong-comment-related-to-link-detection.patch
+++ /dev/null
@@ -1,43 +0,0 @@
-From patchwork Fri Jul 21 18:36:24 2017
-Content-Type: text/plain; charset="utf-8"
-MIME-Version: 1.0
-Content-Transfer-Encoding: 7bit
-Subject: [2/5] e1000e: Fix wrong comment related to link detection
-From: Benjamin Poirier <bpoirier@suse.com>
-X-Patchwork-Id: 9857489
-Message-Id: <20170721183627.13373-2-bpoirier@suse.com>
-To: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
-Cc: Lennart Sorensen <lsorense@csclub.uwaterloo.ca>,
- intel-wired-lan@lists.osuosl.org, netdev@vger.kernel.org,
- linux-kernel@vger.kernel.org
-Date: Fri, 21 Jul 2017 11:36:24 -0700
-
-Reading e1000e_check_for_copper_link() shows that get_link_status is set to
-false after link has been detected. Therefore, it stays TRUE until then.
-
-Signed-off-by: Benjamin Poirier <bpoirier@suse.com>
-Tested-by: Aaron Brown <aaron.f.brown@intel.com>
----
- drivers/net/ethernet/intel/e1000e/netdev.c | 4 ++--
- 1 file changed, 2 insertions(+), 2 deletions(-)
-
---- a/drivers/net/ethernet/intel/e1000e/netdev.c
-+++ b/drivers/net/ethernet/intel/e1000e/netdev.c
-@@ -5082,7 +5082,7 @@ static bool e1000e_has_link(struct e1000
- 
- 	/* get_link_status is set on LSC (link status) interrupt or
- 	 * Rx sequence error interrupt.  get_link_status will stay
--	 * false until the check_for_link establishes link
-+	 * true until the check_for_link establishes link
- 	 * for copper adapters ONLY
- 	 */
- 	switch (hw->phy.media_type) {
-@@ -5100,7 +5100,7 @@ static bool e1000e_has_link(struct e1000
- 		break;
- 	case e1000_media_type_internal_serdes:
- 		ret_val = hw->mac.ops.check_for_link(hw);
--		link_active = adapter->hw.mac.serdes_has_link;
-+		link_active = hw->mac.serdes_has_link;
- 		break;
- 	default:
- 	case e1000_media_type_unknown: